User instructions
E7
E8
E9
68
FAULT | DESCRIPTION |
|
|
| Turbine |
| (for the relevant models only) |
| The appliance is not able to "measure" the amount of |
| water loaded accurately. Interrupt the program and |
| switch off the dishwasher. Switch the dishwasher |
| back on, program it again and start the washing |
| cycle. If the problem persists, contact the |
| service. |
|
|
| Alternate washing system malfunction |
| Interrupt the program and switch off the dishwasher. |
| Switch the dishwasher back on, program it again and |
| start the washing cycle. If the problem persists, |
| contact the |
|
|
| Water intake system malfunction |
| Contact the |
|
|
Light off | Light on | Light flashing |
If an alarm occurs the appliance interrupts the program in progress and signals a fault.
•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.
•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.
•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.