Smeg SUK61IPX5 manual Door glass, Pyrolysis automatic oven cleaning

Instructions for the user

13.6 Door glass

The door glass should always be kept clean. Use absorbent kitchen paper to clean. In case of tough spots, clean with a damp sponge using regular detergent.

When cleaning, the appliance must be dried thoroughly since detergent and water drips might damage its operation and appearance.

13.7 Pyrolysis: automatic oven cleaning

Pyrolysis is an automatic cleaning procedure at high temperatures which destroys all types of dirt.

Before starting the automatic cleaning cycle, make sure that the oven does not contain any foods or large spills from previous cooking operations inside.

A closure device on the door prevents it from being opened whilst cleaning is in progress.

If the oven is installed under the hob, check that the burners or electric plates remain switched off throughout all the automatic cleaning cycle.

13.8 Before starting the automatic cleaning cycle

The automatic pyrolysis cleaning cycle can be programmed at any time of the day or night (to take advantage of any electricity cheap rates).

•Only the pastry tray, the drip tray and the top protection may be left in the oven as they resist the high temperatures of the pyrolysis; all other accessories must be removed from the oven;

•remove the heaviest traces of dirt (as otherwise the pyrolysis cleaning would take too long);

•check that the oven door is properly closed;

•programme the duration of the cycle bearing the table below in consideration:

	SLIGHTLY DIRTY	AVERAGELY DIRTY	VERY DIRTY
CLEANING DURATION:	90 MIN.	120 MIN.	180 MIN.

During the first automatic cleaning cycles, it is possible that unpleasant odours will be released: these are due to the evaporation of oily production materials. This is entirely normal and will disappear after the first cleaning cycle.

During the automatic cleaning cycle, the air fan makes a more intense noise which is due to the increase in their rotation speed. This is a normal result of the facilitation of heat dispersal. At the end of the pyrolysis, the ventilation automatically continues for the amount of time necessary to avoid the walls of the units and the front of the oven overheating.

13.9 Programming the automatic cleaning cycle

Turn the function selector to the symbol to start the pyrolysis cycle. After the orange light of the thermostat has lit up and a few minutes have elapsed, the red «door-block» light also comes on to indicate that the door of the appliance has been locked owing to the high temperature inside the oven.

When the function selector moves to the display will show the symbol: this means that the pyrolysis cycle will start immediately and will last one and a half hours. It is possible to prolong the duration of the pyrolysis up to a maximum of 3 hours. To do so, after the cycle has started press the key and within a few seconds key in the variation of value or . A few seconds after the last keying, the display will show the letter P followed by the duration of the pyrolysis which has just been programmed, and A will stop flashing.

After the pyrolysis has started and after having made any changes to the duration as described above, it is also possible to programme the finishing time of the cleaning cycle.

Press the key. On the display, A will begin to flash and the total of the current time and the duration of the pyrolysis cycle will be displayed. (Example: Current time: 12.10 - Programmed duration: 2.00 - Time shown: 14.10). Now use the keys to change the or values to programme the time of the end of the cleaning cycle. A few seconds after the last keying, the display will show the current time and the orange light will go out and then come back on at the pre-selected time.

Note: do not leave anything in the oven during the pyrolysis cycle. Keep children away and take care above all when the start of the cycle is postponed.

20