Smeg PTS723-3 manual Table of Contents, Electrical connection 4. Gas connection, Using the hob

Page 1
Table of Contents

Table of Contents

1.Precautions for safety and use_________________________ 4

2.Fitting the appliance in the top _________________________ 5

2.1Fixing to the supporting structure ________________________________________5

3.Electrical connection ________________________________ 7

4.Gas connection ____________________________________ 8

4.1Bottled gas connection ________________________________________________9

4.2Room ventilation _____________________________________________________9

4.3Combustion gas discharge _____________________________________________9

5.Adapting to different types of gas______________________ 10

5.1Removing the hob skin _______________________________________________10

5.2Adjusting for bottled gas ______________________________________________11

5.3Adjusting for town gas _______________________________________________11

5.4Adjusting for natural gas ______________________________________________11

5.5Adjusting the primary air flow __________________________________________12

5.6Reassembling the hob skin____________________________________________12

5.7Adjusting the minimum setting for natural gas and town gas __________________12

5.8Adjusting the minimum for bottled gas ___________________________________12

5.9Hob burner layout ___________________________________________________13

5.10Greasing the gas taps________________________________________________13

6.Description of controls ______________________________ 14

6.1The front panel _____________________________________________________14

7.Using the hob _____________________________________ 15

7.1Lighting burners with safety device______________________________________15

7.2Positioning the griddle plate ___________________________________________15

7.3Practical hints for using the burners _____________________________________15

7.4Pan diameters______________________________________________________15

8.Cleaning and maintenance __________________________ 16

8.1Cleaning stainless steel ______________________________________________16

8.2Cleaning the components _____________________________________________16

THESE INSTRUCTIONS ONLY APPLY TO THE COUNTRIES OF DESTINATION WHOSE IDENTIFICATION SYMBOLS ARE LISTED ON THE COVER OF THIS MANUAL.

THIS BUILT-IN HOB IS CLASSIFIED AS CLASS 3.

INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified engineer who is to check the gas supply system and install, commission and test the appliance.

INSTRUCTIONS FOR THE USER: these provide recommendations for use, a description of the controls and the correct procedures for cleaning and maintaining the appliance.

3

Page 1 Page 2
Image 1
Page 1 Page 2
Contents 1. Precautions for safety and use 2. Fitting the appliance in the top Table of Contents7. Using the hob 8. Cleaning and maintenance1. Precautions for safety and use Precautions for Safety and UseNEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF2. Fitting the appliance in the top Instructions for the Installer2.1 Fixing to the supporting structure Fit the insulating gasket provided carefully around the outside edge of the hole made in the top as shown below, pressing it down with your hands so that its entire surface fits snugly. Follow the dimensions shown, depending on the model of hob to be installed, bearing in mind that on both models the long front edge must be flush with the hole. Fix the hob to the structure using the brackets A provided. Carefully trim off the excess edge of the gasket B. The dimensions in the drawing below refer to the hole on the inside edge of the gasket 3. Electrical connection 4. Gas connection 4.2 Room ventilation 4.1 Bottled gas connection4.3 Combustion gas discharge 5.1 Removing the hob skin 5. Adapting to different types of gas5.3 Adjusting for town gas 5.2 Adjusting for bottled gas5.4 Adjusting for natural gas Nominal BurnerheatBottled gas - G30/G31 30/37 mbar capacity kW5.7 Adjusting the minimum setting for natural gas and town gas 5.5 Adjusting the primary air flow5.8 Adjusting the minimum for bottled gas 5.6 Reassembling the hob skin5.10 Greasing the gas taps 5.9 Hob burner layoutBurner type 6. Description of controls Instructions for the User6.1 The front panel 7.1 Lighting burners with safety device 7. Using the hob7.3 Practical hints for using the burners 7.2 Positioning the griddle plate8.1 Cleaning stainless steel 8. Cleaning and maintenance8.2 Cleaning the components Page 914773119/ B
Top Page Image Contents