Instructions for the Installer
2.Fitting the appliance in the top
The procedures required below must be carried out by a skilled builder and/or joiner. The hob can be installed on various materials, including masonry, metal, solid wood and wood finished with plastic laminates, provided the material is
2.1Fixing to the supporting structure
Make a hole in the cabinet top with the dimensions shown here, maintaining a distance of at least 50 mm from the rear edge. This appliance may be installed against walls higher than the worktop surface, provided the distance "X" shown here is maintained, in order to prevent damage due to overheating. Make sure that there is at least 750 mm between the hob burners and a shelf or hood (if any) placed vertically above them.
If the hob is installed above a cupboard with doors, a separator panel must be installed underneath it. Leave a gap of at least 10 mm between the bottom of the hob and the surface of the panel, which must be easily removable to allow sufficient access for any servicing procedures.
Installation of an oven without cooling fan underneath the hob is forbidden.
In case of installation on a hollow compartment with doors, a separating panel has to
be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the unit and the panel surface. The panel has to be easily removable to allow access in the event of technical service.
5