Smeg PTS723-3 manual Electrical connection, Instructions for the Installer

Contents 1. Precautions for safety and use 2. Fitting the appliance in the top Table of Contents7. Using the hob 8. Cleaning and maintenance1. Precautions for safety and use Precautions for Safety and UseNEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF2.1 Fixing to the supporting structure Instructions for the Installer2. Fitting the appliance in the top Fit the insulating gasket provided carefully around the outside edge of the hole made in the top as shown below, pressing it down with your hands so that its entire surface fits snugly. Follow the dimensions shown, depending on the model of hob to be installed, bearing in mind that on both models the long front edge must be flush with the hole. Fix the hob to the structure using the brackets A provided. Carefully trim off the excess edge of the gasket B. The dimensions in the drawing below refer to the hole on the inside edge of the gasket 3. Electrical connection 4. Gas connection 4.3 Combustion gas discharge 4.1 Bottled gas connection4.2 Room ventilation 5.1 Removing the hob skin 5. Adapting to different types of gas5.3 Adjusting for town gas 5.2 Adjusting for bottled gas5.4 Adjusting for natural gas Nominal BurnerheatBottled gas - G30/G31 30/37 mbar capacity kW5.7 Adjusting the minimum setting for natural gas and town gas 5.5 Adjusting the primary air flow5.8 Adjusting the minimum for bottled gas 5.6 Reassembling the hob skinBurner type 5.9 Hob burner layout5.10 Greasing the gas taps 6.1 The front panel Instructions for the User6. Description of controls 7.1 Lighting burners with safety device 7. Using the hob7.3 Practical hints for using the burners 7.2 Positioning the griddle plate8.2 Cleaning the components 8. Cleaning and maintenance8.1 Cleaning stainless steel Page 914773119/ B