Smeg PTS723-3 manual Hob burner layout, Greasing the gas taps, Instructions for the Installer

Contents 8. Cleaning and maintenance Table of Contents1. Precautions for safety and use 2. Fitting the appliance in the top 7. Using the hobNEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF Precautions for Safety and Use1. Precautions for safety and use NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD2.1 Fixing to the supporting structure Instructions for the Installer2. Fitting the appliance in the top Fit the insulating gasket provided carefully around the outside edge of the hole made in the top as shown below, pressing it down with your hands so that its entire surface fits snugly. Follow the dimensions shown, depending on the model of hob to be installed, bearing in mind that on both models the long front edge must be flush with the hole. Fix the hob to the structure using the brackets A provided. Carefully trim off the excess edge of the gasket B. The dimensions in the drawing below refer to the hole on the inside edge of the gasket 3. Electrical connection 4. Gas connection 4.3 Combustion gas discharge 4.1 Bottled gas connection4.2 Room ventilation 5.1 Removing the hob skin 5. Adapting to different types of gasNominal BurnerheatBottled gas - G30/G31 30/37 mbar capacity kW 5.2 Adjusting for bottled gas5.3 Adjusting for town gas 5.4 Adjusting for natural gas5.6 Reassembling the hob skin 5.5 Adjusting the primary air flow5.7 Adjusting the minimum setting for natural gas and town gas 5.8 Adjusting the minimum for bottled gasBurner type 5.9 Hob burner layout5.10 Greasing the gas taps 6.1 The front panel Instructions for the User6. Description of controls 7.2 Positioning the griddle plate 7. Using the hob7.1 Lighting burners with safety device 7.3 Practical hints for using the burners8.2 Cleaning the components 8. Cleaning and maintenance8.1 Cleaning stainless steel Page 914773119/ B