Smeg LVS1449B instruction manual User instructions, Adding The Detergent

Page 22
ADDING THE DETERGENT

User instructions

ADDING THE DETERGENT

To open the detergent dispenser cap, lightly press the button P. Add the detergent and close the cap carefully.

During the washing cycle, the dispenser will be opened automatically.

When a program with hot prewash is selected (see program table), extra detergent must be placed in the cavity G/H (depending on models).

Use only detergents specially formulated for dishwashers. For optimal washing results it is important to use a good quality detergent.

The detergent packs must be sealed and stored in a dry place to prevent the formation of lumps which may negatively affect washing results. Once opened the detergent packs should not be kept for too long, otherwise the detergent loses its effectiveness.

Do not use detergents formulated for washing dishes by hand, because they produce a great deal of foam and may negatively affect the operation of the dishwasher.

Add the correct amount of detergent. An insufficient amount of detergent will result in a partial removal of dirt from the dishes, whereas an excessive amount is wasteful and does not improve the washing results.

21

Image 22
Contents GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS Contents Safety instructions 1. Safety and operating instructionsTHIS DISHWASHER MUST BE USED BY ADULTS AQUASTOP MODELS 2. Installation and hook-up Installation instructionsFor free-standing models only 2.1 Water supply connection CONNECTING TO THE WATER SUPPLYDRAIN CONNECTION 2.2 Electrical connection and precautions IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORDFuse replacement FOR GREAT BRITAIN ONLY6 START/STOP BUTTON 7 POWER ON LIGHT User instructions3. Description of the controls 3.1 Front panelOnly run the soak program with half loads The correct amount of detergent has been added to the dispenser 3.3 Washing programsBefore starting a washing program make sure that LIGHTINGEND PROGRAM SELECTION PROGRAMSTART PROGRAM INTERRUPTING A PROGRAMTO CHANGE A PROGRAM STOPPING A PROGRAMParticularly, on the display it will have the following indications HALF LOAD WASH FUNCTION on some models only TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENTREMOVING THE DISHES 4. Operating instructions 4.1 Using the water softening systemUser instructions 4.2 Using the rinse aid and detergent dispensers WATER HARDNESS TABLEADJUSTING THE RINSE AID DISPENSER SETTING ADDING THE RINSE AIDADDING THE DETERGENT During the washing cycle, the dispenser will be opened automaticallyUser instructions Correct loading of the dishes helps ensure optimal washing results 4.3 General warnings and recommendationsMAKE SURE that the items being washed are dishwasher-safe Items which are not dishwasher-safe Dishes and objects in copper, tin, zinc or brass these tend to stain4.4 Using the baskets LOWER BASKETLOADING THE LOWER BASKET Loading examples ½ LOADCUTLERY BASKET UPPER BASKET LOADING THE UPPER BASKETADJUSTING THE UPPER BASKET Version BUser instructions CLEANING THE SPRAY ARMS 5. Cleaning and maintenanceCLEANING THE WATER INTAKE FILTER 5.1 General warnings and recommendationsPROLONGED DISUSE CLEANING THE FILTER UNITGENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE Fill the rinse aid dispenser Shut off the water supply tapBEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE TROUBLESHOOTING MINOR PROBLEMSIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap againIf the dishes show signs of streaking, staining, etc., check that If the dishes fail to dry or remain dull, check thatIf there are visible traces of rust inside the tank FAULT 6. TroubleshootingTABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM E1 E2 E3 E4 E5 E6 E7 E8 E9Width TECHNICAL DATAElectrical characteristics CapacityMontare la porta e regolarelatensione delle mollelaterali primadell’installazionedes ressortslateraux avant l’installation einstellen