Smeg LVS1449B instruction manual Installation instructions, Electrical connection and precautions

Page 8

2.2 Electrical connection and precautions

Installation instructions

2.2 Electrical connection and precautions

CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR.

THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE.

THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED BY THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE.

DO NOT USE ADAPTORS OR SHUNT CONNECTIONS IN ORDER TO AVOID THE POSSIBILITY OF OVERHEATING OR BURNING.

IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:

IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTACTS OF AT LEAST 3.5MM. AFTER INSTALLATION THE DISCONNECTION DEVICE HAS TO BE EASY TO REACH.

THE CONNECTION TO THE MAINS MUST BE CARRIED OUT BY A QUALIFIED TECHNICIAN IN ACCORDANCE TO THE SCHEME SHOWN BELOW AND THE REGULATIONS IN FORCE.

L = brown N = blue

= yellow-green

In the event of damage to the supply cord, have it replaced by the manufacturer or an Authorized Technical Service Centre in order to avoid any risk.

7

Image 8

Contents GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS Contents Safety instructions 1. Safety and operating instructionsTHIS DISHWASHER MUST BE USED BY ADULTS AQUASTOP MODELS For free-standing models only Installation instructions2. Installation and hook-up DRAIN CONNECTION CONNECTING TO THE WATER SUPPLY2.1 Water supply connection 2.2 Electrical connection and precautions IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORDFuse replacement FOR GREAT BRITAIN ONLYUser instructions 3. Description of the controls6 START/STOP BUTTON 7 POWER ON LIGHT 3.1 Front panelOnly run the soak program with half loads 3.3 Washing programs Before starting a washing program make sure thatThe correct amount of detergent has been added to the dispenser LIGHTINGSELECTION PROGRAM START PROGRAMEND PROGRAM INTERRUPTING A PROGRAMTO CHANGE A PROGRAM STOPPING A PROGRAMParticularly, on the display it will have the following indications HALF LOAD WASH FUNCTION on some models only REMOVING THE DISHES TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENTTO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT 4. Operating instructions 4.1 Using the water softening systemUser instructions 4.2 Using the rinse aid and detergent dispensers WATER HARDNESS TABLEADJUSTING THE RINSE AID DISPENSER SETTING ADDING THE RINSE AIDADDING THE DETERGENT During the washing cycle, the dispenser will be opened automaticallyUser instructions MAKE SURE that the items being washed are dishwasher-safe 4.3 General warnings and recommendationsCorrect loading of the dishes helps ensure optimal washing results Items which are not dishwasher-safe Dishes and objects in copper, tin, zinc or brass these tend to stain4.4 Using the baskets LOWER BASKETLOADING THE LOWER BASKET Loading examples ½ LOADCUTLERY BASKET UPPER BASKET LOADING THE UPPER BASKETADJUSTING THE UPPER BASKET Version BUser instructions 5. Cleaning and maintenance CLEANING THE WATER INTAKE FILTERCLEANING THE SPRAY ARMS 5.1 General warnings and recommendationsCLEANING THE FILTER UNIT GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCEPROLONGED DISUSE Fill the rinse aid dispenser Shut off the water supply tapTROUBLESHOOTING MINOR PROBLEMS If the dishes are not being cleaned properly, check thatBEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE Reconnect the water intake hose and open the tap againIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatIf the dishes show signs of streaking, staining, etc., check that 6. Troubleshooting TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEMFAULT E1 E2 E3 E4 E5 E6 E7 E8 E9TECHNICAL DATA Electrical characteristicsWidth Capacitymollelaterali primadell’installazione des ressortslateraux avant l’installationMontare la porta e regolarelatensione delle einstellen