Smeg
LVS1449B User instructions, Technical Data, Width, Capacity, Water supply pressure
Troubleshooting
Electrical characteristics
Install
Fault
Connecting To The Water Supply
Adjusting The Upper Basket
Cleaning and maintenance
Fuse replacement
Safety
Using the baskets
Page 37
Page 36
Page 38
Image 37
Page 36
Page 38
Contents
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
Contents
1. Safety and operating instructions
Safety instructions
THIS DISHWASHER MUST BE USED BY ADULTS
AQUASTOP MODELS
2. Installation and hook-up
Installation instructions
For free-standing models only
2.1 Water supply connection
CONNECTING TO THE WATER SUPPLY
DRAIN CONNECTION
IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD
2.2 Electrical connection and precautions
FOR GREAT BRITAIN ONLY
Fuse replacement
3. Description of the controls
User instructions
6 START/STOP BUTTON 7 POWER ON LIGHT
3.1 Front panel
Only run the soak program with half loads
Before starting a washing program make sure that
3.3 Washing programs
The correct amount of detergent has been added to the dispenser
LIGHTING
START PROGRAM
SELECTION PROGRAM
END PROGRAM
INTERRUPTING A PROGRAM
STOPPING A PROGRAM
TO CHANGE A PROGRAM
Particularly, on the display it will have the following indications
HALF LOAD WASH FUNCTION on some models only
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
REMOVING THE DISHES
4.1 Using the water softening system
4. Operating instructions
User instructions
WATER HARDNESS TABLE
4.2 Using the rinse aid and detergent dispensers
ADDING THE RINSE AID
ADJUSTING THE RINSE AID DISPENSER SETTING
During the washing cycle, the dispenser will be opened automatically
ADDING THE DETERGENT
User instructions
Correct loading of the dishes helps ensure optimal washing results
4.3 General warnings and recommendations
MAKE SURE that the items being washed are dishwasher-safe
Dishes and objects in copper, tin, zinc or brass these tend to stain
Items which are not dishwasher-safe
LOWER BASKET
4.4 Using the baskets
Loading examples ½ LOAD
LOADING THE LOWER BASKET
CUTLERY BASKET
LOADING THE UPPER BASKET
UPPER BASKET
Version B
ADJUSTING THE UPPER BASKET
User instructions
CLEANING THE WATER INTAKE FILTER
5. Cleaning and maintenance
CLEANING THE SPRAY ARMS
5.1 General warnings and recommendations
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE
CLEANING THE FILTER UNIT
PROLONGED DISUSE
Fill the rinse aid dispenser Shut off the water supply tap
If the dishes are not being cleaned properly, check that
TROUBLESHOOTING MINOR PROBLEMS
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE
Reconnect the water intake hose and open the tap again
If the dishes show signs of streaking, staining, etc., check that
If the dishes fail to dry or remain dull, check that
If there are visible traces of rust inside the tank
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
6. Troubleshooting
FAULT
E1 E2 E3 E4 E5 E6 E7 E8 E9
Electrical characteristics
TECHNICAL DATA
Width
Capacity
des ressortslateraux avant l’installation
mollelaterali primadell’installazione
Montare la porta e regolarelatensione delle
einstellen
Related pages
All Characteristic page
System Electrical and Electro- Acoustical Characteristics for Bosch Appliances CCS 800 Ultro
Termination transmission characteristics for Nortel Networks 553-3001-211
Physical Characteristics for Texas Memory Systems RAM-SAN 520
Measurement Port Characteristics for Agilent Technologies 85225F
Switching Characteristics Over the Operating Range 11 for Cypress CY7C1329H
Font Characteristics for Konica Minolta IP-411
Electrical Characteristics for Plasmon FS3102
Electrical Characteristics At 25oC 100KHz for Delta Electronics THMR1395
Are there any optional brackets needed for
JUSB2
connections?
Top
Page
Image
Contents