Smeg LVF649B User instructions, E7 E8 E9, Fault, Description, Turbine flow-regulatormalfunction

E7

E8

E9

User instructions

FAULT	DESCRIPTION
	Turbine flow-regulator malfunction
	The appliance is not able to "measure" the
	amount of water loaded accurately. Interrupt
	the program and switch off the dishwasher.
	Switch the dishwasher back on, program it
	again and start the washing cycle. If the
	problem persists, contact the after-sales
	service.
	Alternate washing system malfunction
	Interrupt the program and switch off the
	dishwasher. Switch the dishwasher back on,
	program it again and start the washing cycle. If
	the problem persists, contact the after-sales
	service.
	Water intake system malfunction
	Contact the after-sales service.

Light off Light on Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

33