Smeg CE6IPX manual Installing the Appliance, Electrical connection

Page 28

Instructions for the installer

15.INSTALLING THE APPLIANCE

The appliance must be installed by a qualified technician and according to the standards in force.

This appliance may be installed next to a wall which is higher than the appliance, with a minimum distance of 5 cm from the side of the appliance, as shown in drawings A and B showing the correct installation conditions. Any wall cupboards or shelves must be at a distance of at least 75 cm above the work surface.

A)

Built-in appliance

15.1Electrical connection

B)

Free-standing appliance

Make sure the voltage and the cross-section of the power cord match the specifications indicated on the rating plated positioned in the storage compartment. Do not remove this plate for any reason.

If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm located near the appliance and in an easily reachable position.

Connection to the supply may be fixed or with plug and socket. In the latter case the plug and socket must be suitable for the cable employed and conform with the regulations in force. Regardless of the type of connection, the appliance absolutely must be earthed. Before connection make sure that the supply line is suitably earthed. Avoid the use of reducers, adapters or shunts which may cause overheating.

59

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Index Precautions for USE Plate Must not be RemovedRecycling Instructions OUR Environment Policy Intended USE Safety PrecautionsNever Attempt to Repair the Appliance Yourself Getting to Know Your Ovenl General DescriptionAvailable Accessories Before InstallationAccessories available on request Using the Rotisserie ROD when present Description of the Controls on the Front Panel Main Oven Functions Selection Knob PT2 Main Oven Temperature Selection Knob PT1HOB Control Knob Using the Main Oven Setting the current timeFirst use Selecting a functionProgrammed cooking procedures 10.4.1Semiautomatic cookingModifying the data set 10.4.2Automatic cookingModifying the data set during cooking Cooking with selection of a recipeAutomatic cooking with selection of a recipe Making permanent changes to a recipe Table of predefined recipes Secondary menu Cooking in the Oven Description of the selected functionsHints on Using the Accessories Cooking Hints and TipsCooking tables Using the HOB Cooking zonesZone number Zone Diameter Power consumed 145 mm Total power consumed180 mm 210 mmCookware detector signal Operation Activating temperatureResidual heat Cooking hob lock-outThermal protection glass-ceramic hob Keep Warm FunctionCleaning and Maintenance Pyrolysis automatic oven cleaning on some models only Before starting the automatic cleaning cycle Setting the cleaning cycle Extraordinary Maintenance Changing the light bulbRemoving the door Removing the door sealWhat to do if Oven display is completely offOven does not heat up Controls do not respondInstalling the Appliance Electrical connectionPositioning and levelling the appliance depending on model
Top Page Image Contents