Instructions for the User
4.6.1 Extending a cooking operation
When a cooking operation finishes, it is possible to extend it manually:
•While the display is showing the message “End”, press the “START” button; the text “tP00” will appear on the display.
•Turn the knob to the 
or 
symbols to set the additional minutes of cooking; at most 20 extra minutes are allowed.
•To start the cooking extra time that has just been set, press the “START” button for at least 2 seconds.
•At the end of cooking, the text “End” will continue to flash for the next 20 minutes and the oven light will remain on.
4.7Manual cooking
The manual program is “P40” and can be edited by the user, but does not save the cooking parameters set in memory. To select this program proceed as follows:
•Save the program temporarily, as described in chapter 4.5 Editing / saving a program. Unlike saved programs, the cooking time can be set to infinite; the display will show the text “InF”.
•After saving it, DO NOT return to the “OFF” condition. Press the “START” button. The appliance will perform a
•When preheating is finished, a series of beeps lasting 3 seconds indicate that is possible to proceed with the cooking operation. The text “PrEh” will flash on the display.
•To start the cooking, keep the “START” button pressed for 2 seconds. The display will show, in order, the temperature set, the time remaining until the end of cooking and the program selected.
•It is possible to start the cooking early before the preheating temperature is reached, by keeping the “START” button pressed for 3 seconds.
•During cooking, it is possible to modify the temperature by turning the knob to the 
or 
symbols; it will continue with the new setting after 3 seconds.
•During the last minute of cooking, only the countdown of the remaining 60 seconds will be displayed. At the end, a beep and the text “End” flashing (for 20 minutes) will indicate that the cooking has been completed.
•At the end of the cooking operation, to perform the same program again press the “START” button once more.
•To return to the “OFF” condition keep the “STOP” button pressed for 4 seconds. The parameters set for the program are deleted.
32