Reverse door swing
Required tools; socket spanner nr. 8, screwdriver, torx 25.
Caution! After unscrewing of before fixing hinges, hold the door to prevent it from falling and damaging.
1.Remove upper hinge cover (save it for eventual later use), remove also the cover on the opposite side of the upper hinge cover (on the opposite side you will insert the attached cover during the assembly), and remove the cover on the opposite side of the upper part of the door.
2.Unscrew upper hinge screws and remove the upper door from the middle hinge.
3.On the bottom side of the upper door unscrew the swing stopper screws and remove the stopper
(A). Keep this for eventual use later on. Fix the attached stopper with its bearing on the opposite side of the door.
4.Unscrew the forced door closure system (B) and fix it to the opposite side of the door (certain models only).
5.Unscrew middle hinge screws, remove the door from bottom hinge.
6.Unscrew leg holder fixing screws.
7.Tilt the appliance backward (max. 35°) to lean to the rear side of the cabinet. Unscrew the leg support screws (C) - left and right, and remove the leg support cover (D) and place it to the opposite side. Unscrew and remove, then reciprocally replace the position of end switch (E) and decorative peg (F) (for models with forced door closing system). Unscrew three screws fixing the bottom hinge (save the hinge for later use), and fix the attached bottom hinge on the
opposite side.
8. Repeat the procedure 3 and 4 on the bottom
door. In case there is no bottom door limit peg, |
|
transfer the bearing (G) and washer to the |
|
opposite side of the door. | 142468 |
|
9