II. RECEIPT INSPECTION
All Traulsen products are factory tested for perfor- mance and are free from defects when shipped. The utmost care has been taken in crating this product to protect against damage in transit. All interior fittings have been carefully secured and the legs or casters are boxed and strapped inside to prevent damage.
You should carefully inspect your Traulsen unit for damage during delivery. If damage is detected, you should save all the crating materials and make note on the carrier's Bill Of Lading describing this. A freight claim should be filed immediately. If damage is sub- sequently noted during or immediately after installa- tion, contact the respective carrier and file a freight claim. Under no condition may a damaged unit be re- turned to Traulsen & Co. without first obtaining writ- ten permission (return authorization).
III.INSTALLATION (continued)
III.c - INSTALLING LEGS OR CASTERS (cont'd):
the factory inside a cardboard box which is secured inside the cabinet. Casters in lieu of legs are supplied as an optional accessory for all compact undercounter models. The casters are “stem” type, and do not re- quire the use of any bolts. When ordered, casters are shipped in a separate box.
WARNING: THE CABINET MUST BE BLOCKED AND STABLE BEFORE INSTALLING LEGS OR CASTERS.
Raise up and block the cabinet a minimum of 7" from the floor and thread the legs into the threaded holes on the bottom of the cabinet (see figure 1).
III.INSTALLATION
III.a - LOCATION:
Select a proper location for your Traulsen unit, away from extreme heat or cold. Condenser performance is dependent on adequate ventilation for cooling purposes. Adequate clearance MUST be provided for the ventilator locations underneath. There are no clearance requirements for sides, rear, or top.
NOTE: Do not install the cabinet without legs, cast- ers or front ventilated utility base.
III.b - PACKAGING:
All Traulsen units are shipped from the factory bolted to a sturdy wooden pallet and packaged in a durable cardboard container. The carton is attached to the wooden skid with the use of large staples. These should first be removed to avoid scratching the unit when lifting off the crate.
To remove the wooden pallet, first if at all possible, we suggest that the cabinet remain bolted to the pallet during all transportation to the point of final installa- tion. The bolts can then be removed with a 5/8” socket wrench by tipping or otherwise raising the unit to al- low access to them. Avoid laying the unit on its front, side or back for removal of the pallet.
NOTE: Traulsen does not recommend laying the unit down on its front, side or back. However, if you must please be certain to allow the unit to remain in an up- right position afterwards for 24 hours before plugging it in so that the compressor oils and refrigerant may settle.
III.c - INSTALLING LEGS OR CASTERS:
6” high legs are supplied standard for all Traulsen compact undercounter units. These are shipped from
Fig. 1
Thread optional casters into the threaded holes on the bottom of the cabinet inthesameway(see figure 2). Casters with brake should be installed at the front.
Fig. 2
Level the cabinet using a level or pan of water in the bottom of the cabinet. On units with legs, turn the adjustable feet in or out to level the cabinet