True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS FOR OPTIONAL LID LOCK KIT FOR TDC MODELS ONLY.
REQUIRED TOOLS
•Drill
•5/16” inch drill bit
•Padlock
Bracketr t Partrt # 913544
Image 1 (TDC Lock Bracket)
STEP 1
Slide lock bracket under stainless steel trim near center of lid. (See image
STEP 2
Remove the lock bracket after marking the hole location. Then drill 5/16” diameter hole centered on back of the Dipping cabinet aluminum handle. (See image 3 & illustrations below).
STEP 3
Reinstall the lock bracket. Slip the hooked end of the lock bracket under the stainless steel top (See image 4). Pull out and up to allow the lock bracket to pass over the aluminum handle. Place a padlock through the lock bracket and handle.
(See image 5).
1). Mark the hole location of the lock bracket on the Dipping cabinet handle.
Image 3 (Drilling lock bracket hole)
Image 4
Image 2
Drill Hole Centered on | Image 5 |
Handle |
|
Lock Bracket Centered |
|
| A |
Lock Bracket |
|
8 | www.truemfg.com | 8 |