PROBLEM
Burner flames lift off ports, are yellow, or are noisy when turned off
Burner makes popping noise when on
Control knob(s) will not turn
Cooking results are not what you expected
The display is showing “88:88”
POSSIBLE CAUSE
Air/gas mixture is incorrect.
Burner is wet from washing.
You are not pushing in before turning.
The range is not level.
The oven temperature seems too low or too high.
The oven was not preheated as the recipe calls for.
The recipe has never been tested or is not from a reliable source.
The pans are not the type or size recommended in the recipe.
There is not proper air circu- lation around pan when baking.
Flame size does not fit the cooking utensil being used.
When broiling, you have not completely closed the broiler drawer.
There has been a power failure.
SOLUTION
Contact an authorized Whirlpool service technician to check air/gas mixture.
Let dry.
Push control knob(s) in before turning to a setting.
Level range. (See Installation
Instructions.)
Adjust the oven temperature control. (See “Adjusting the oven temperature control” on page 13.)
Preheat oven if called for in recipe.
Use only tested recipes from a reliable source.
Refer to a reliable cookbook for recom- mended pan type and size.
Allow 1M to 2 inches
Adjust flame size to fit cooking utensil.
Completely close broiler drawer.
Reset the clock. (See page 10.)
25