Whirlpool W10196160D Storage Drawer, Complete Installation, To Remove, To Replace

Page 11

Storage Drawer

The storage drawer can be removed. Before removing, check that the storage drawer is cool and empty. A flat-blade screwdriver will be needed for removal.

To Remove:

1.Pull the storage drawer forward to the drawer stop. Push the drawer back approximately 1" ( 2.5 cm).

It will be necessary to disengage the storage drawer one side at a time.

2.Insert a flat-blade screwdriver through the opening in the side of the storage drawer, placing the screwdriver tip on the outside of the drawer clip.

A

3.Depress the drawer clip by pressing the screwdriver handle toward the side of the storage drawer.

A

A. Drawer clip - view from outside of storage drawer

4.Gently pull forward on the storage drawer until the depressed clip clears the drawer glide.

5.Repeat steps 2-4, for the other side of the storage drawer.

6.Lift up the back of the storage drawer and remove.

To Replace:

1.Lift up the back of the storage drawer and place it inside the range in its fully forward position.

2.Lift up the front of the storage drawer to a level position.

3.Slowly push the storage drawer into the range until the drawer side rails engage with the gap in the drawer glides.

A

A. Engage drawer glide.

4.

Once the storage drawer is fully engaged on both sides, slide

A. Drawer clip

the drawer back into the closed position.

 

5.

NOTE: When you are removing and replacing the storage

 

drawer, a slight push may be needed to move the drawer stop

 

notch past the drawer glides.

 

 

Complete Installation

1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check that you have all of your tools.

3.Dispose of/recycle all packaging materials.

4.Check that the range is level. See “Level Range.”

5.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see the “Range Care” section of the Use and Care Guide.

6.Read the Use and Care Guide.

7.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.

If range does not operate, check the following:

■Household fuse is intact and tight, or circuit breaker has not tripped.

■Range is plugged into a grounded 3 prong outlet.

■Electrical supply is connected.

■See “Troubleshooting” in the Use and Care Guide.

8.When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open.

■If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above.

■If the gas supply line shutoff valve is open, press the CANCEL button on the oven control panel and contact a qualified technician.

If you need Assistance or Service:

Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your range.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Range Safety Instructions D’INSTALLATION DES Cuisinières À GAZWhat to do if YOU Smell GAS Location Requirements Installation RequirementsTools and Parts Cabinet Dimensions Product DimensionsGas Supply Line Electrical RequirementsGas Supply Requirements Type of GasBurner Input Requirements Gas Supply Pressure TestingUnpack Range Gas Pressure RegulatorTypical rigid pipe connection Install Anti-Tip BracketMake Gas Connection Plug into a grounded 3 prong outlet Verify Anti-Tip Bracket LocationTypical flexible connection Complete ConnectionElectronic Ignition System Level RangeCheck Operation of Oven Broil Burner Adjust Oven Bake Burner Flame if neededAdjust Oven Broil Burner Flame if needed Replace Oven Racks Warming DrawerTo Remove Complete InstallationIf you need Assistance or Service Storage DrawerTo Convert Surface Burners GAS ConversionsLP Gas Conversion To Convert Gas Pressure RegulatorTo Convert Oven Broil Burner Complete InstallationTo Convert Oven Bake Burner Natural Gas Conversion Stamped number Votre sécurité et celle des autres est très importante Sécurité DE LA CuisinièreOutillage et pièces Exigences D’INSTALLATIONEmplacement d’installation Dimensions du placard Dimensions de lappareilGaz naturel Spécifications électriquesSpécifications de l’alimentation en gaz Type de gazTests de pressurisation de la canalisation de gaz Canalisation dalimentation en gazDétendeur Débit thermique des brûleursSur les cuisinières équipées d’un tiroir de remisage Instructions DinstallationInstallation de la bride antibasculement Déballage de la cuisinièreSous la cuisinière Déplacer la cuisinière vers son emplacement final enRaccordement à la canalisation de gaz Raccordement typique à une canalisation rigideCompléter le raccordement Vérification de lemplacement de la Bride antibasculementMise à niveau de la cuisinière Raccordement typique par raccord flexibleRéglage de la taille des flammes Système dallumage électroniqueAllumage initial et réglages des flammes Si le brûleur ne sallume pas correctementSil est nécessaire de régler la taille des flammes Contrôle du fonctionnement du brûleur du grilPour ôter le répartiteur de flammes Utilisation dun miroirTiroir De Remisage Réinstallation des grilles du four et du Tiroir-réchaudAchever l’installation Conversion du détendeur Conversions Pour Changement DE GAZConversion de Gaz naturel à Propane Ôter les grilles du four Conversion des brûleurs de la table de cuissonConversion du brûleur du four Conversion du brûleur du gril Achever linstallationConversion de Propane à Gaz naturel Marquage didentification Conversion du brûleur du four W10196160D

W10196160D specifications

The Whirlpool W10196160D is a cutting-edge appliance designed to enhance the functionality and efficiency of modern kitchens. This product is particularly known for its reliability and user-friendly features, making it a preferred choice for homeowners and culinary enthusiasts alike.

One of the standout features of the Whirlpool W10196160D is its advanced technology that ensures optimal performance. The appliance incorporates Smart Sensor technology, allowing it to automatically detect the proper cycle settings based on the type of food being cooked. This innovative feature helps in achieving perfect cooking results every time while minimizing energy usage.

The W10196160D also boasts a spacious capacity, accommodating large meals and multiple dishes simultaneously. This is particularly beneficial for families or those who frequently entertain guests. The interior design is engineered for easy cleaning, with smooth surfaces that resist stains and odors, maintaining hygiene and a pristine appearance over time.

Energy efficiency is a hallmark of the Whirlpool brand, and the W10196160D is no exception. It meets rigorous energy-saving guidelines, which not only reduces environmental impact but also leads to lower utility bills. The appliance operates quietly, allowing you to enjoy conversations in your kitchen without disruptive noises.

Another feature of the Whirlpool W10196160D is its intuitive control panel. It features simple touch controls that enable users to easily adjust settings and monitor cooking progress. The clear display provides all necessary information at a glance, making it perfect for those who may not be tech-savvy.

Safety is also a primary consideration in the design of the W10196160D. It comes equipped with child lock features, ensuring that the appliance remains secure and functions safely in homes with young children. Additionally, its durable construction is designed to withstand the rigors of everyday use.

In summary, the Whirlpool W10196160D is an impressive appliance characterized by its smart technology, large capacity, energy-efficiency, user-friendly interface, and enhanced safety features. This makes it an ideal addition to any kitchen, combining function with style while delivering exceptional cooking results.
Top Page Image Contents