Whirlpool W10196160D To Convert Oven Bake Burner, To Convert Oven Broil Burner

Page 13

NOTE: Reinstall one of the screws through the range cooktop to hold the orifice spud holder in place while removing and replacing the orifice spuds.

C

A

D

B

A. Igniter electrode

B. Gas tube opening

C. Burner cap

D. Burner base

3.Apply masking tape to the end of a ⁵⁄₁₆" nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside.

C

A

D

B

A.Orifice spud

B.Orifice spud holder

C.Screw

D.Spark electrode

4.Remove the cardboard orifice spud holder located on the back of the range near the gas inlet. Gas orifice spuds are stamped with a number, marked with 1 color dot, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct LP gas orifice spud.

A

A. Groove

Refer to the following chart for correct LP gas orifice spud placement.

LP Gas Orifice Spud Chart for Surface Burners

Burner Rating

Color

Size

ID Number

 

 

 

 

14,000 BTU

Yellow/Orange

1.07 mm

L107

11,000 BTU

Yellow/Brown

0.99 mm

L99

8,000 BTU

Yellow/Black

0.85 mm

L85

5,000 BTU

Yellow/White

0.70 mm

L70

NOTE: Refer to the Model Number and Serial Number Plate located behind the left side of the storage or warming drawer for proper sizing of spuds for each burner location.

5.Place Natural gas orifice spuds in the cardboard orifice spud holder.

6.Replace the burner base using both screw.

7.Replace burner cap.

8.Repeat steps 1-7 for the remaining burners.

To Convert Oven Bake Burner

1.Remove oven racks.

2.Use a ½" combination wrench to turn the orifice hood down snug onto pin (about 2 to 2½ turns).

IMPORTANT: Do not overtighten.

The oven bake burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Bake Burner Flame” in the “Electronic Ignition System” section.

A

B

A

A

A. Orifice hood

B. Pin

To Convert Oven Broil Burner

Use a ½" combination wrench to turn the orifice hood down snug onto the pin (about 2 to 2½ turns).

IMPORTANT: Do not overtighten.

The oven broil burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Broil Burner Flame” in the “Electronic Ignition System” section.

A

B

A. Lock screw

B. Orifice hood

Complete Installation

1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.

2.Refer to the “Electronic Ignition System” section for proper burner ignition, operation, and burner flame adjustments.

IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Range Safety Instructions D’INSTALLATION DES Cuisinières À GAZWhat to do if YOU Smell GAS Tools and Parts Installation RequirementsLocation Requirements Cabinet Dimensions Product DimensionsGas Supply Requirements Electrical RequirementsType of Gas Gas Supply LineUnpack Range Gas Supply Pressure TestingGas Pressure Regulator Burner Input RequirementsMake Gas Connection Install Anti-Tip BracketTypical rigid pipe connection Typical flexible connection Verify Anti-Tip Bracket LocationComplete Connection Plug into a grounded 3 prong outletElectronic Ignition System Level RangeAdjust Oven Broil Burner Flame if needed Adjust Oven Bake Burner Flame if neededReplace Oven Racks Warming Drawer Check Operation of Oven Broil BurnerIf you need Assistance or Service Complete InstallationStorage Drawer To RemoveLP Gas Conversion GAS ConversionsTo Convert Gas Pressure Regulator To Convert Surface BurnersTo Convert Oven Bake Burner Complete InstallationTo Convert Oven Broil Burner Natural Gas Conversion Stamped number Votre sécurité et celle des autres est très importante Sécurité DE LA CuisinièreEmplacement d’installation Exigences D’INSTALLATIONOutillage et pièces Dimensions du placard Dimensions de lappareilSpécifications de l’alimentation en gaz Spécifications électriquesType de gaz Gaz naturelDétendeur Canalisation dalimentation en gazDébit thermique des brûleurs Tests de pressurisation de la canalisation de gazInstallation de la bride antibasculement Instructions DinstallationDéballage de la cuisinière Sur les cuisinières équipées d’un tiroir de remisageRaccordement à la canalisation de gaz Déplacer la cuisinière vers son emplacement final enRaccordement typique à une canalisation rigide Sous la cuisinièreMise à niveau de la cuisinière Vérification de lemplacement de la Bride antibasculementRaccordement typique par raccord flexible Compléter le raccordementAllumage initial et réglages des flammes Système dallumage électroniqueSi le brûleur ne sallume pas correctement Réglage de la taille des flammesPour ôter le répartiteur de flammes Contrôle du fonctionnement du brûleur du grilUtilisation dun miroir Sil est nécessaire de régler la taille des flammesAchever l’installation Réinstallation des grilles du four et du Tiroir-réchaudTiroir De Remisage Conversion de Gaz naturel à Propane Conversions Pour Changement DE GAZConversion du détendeur Conversion du brûleur du four Conversion des brûleurs de la table de cuissonÔter les grilles du four Conversion de Propane à Gaz naturel Achever linstallationConversion du brûleur du gril Marquage didentification Conversion du brûleur du four W10196160D

W10196160D specifications

The Whirlpool W10196160D is a cutting-edge appliance designed to enhance the functionality and efficiency of modern kitchens. This product is particularly known for its reliability and user-friendly features, making it a preferred choice for homeowners and culinary enthusiasts alike.

One of the standout features of the Whirlpool W10196160D is its advanced technology that ensures optimal performance. The appliance incorporates Smart Sensor technology, allowing it to automatically detect the proper cycle settings based on the type of food being cooked. This innovative feature helps in achieving perfect cooking results every time while minimizing energy usage.

The W10196160D also boasts a spacious capacity, accommodating large meals and multiple dishes simultaneously. This is particularly beneficial for families or those who frequently entertain guests. The interior design is engineered for easy cleaning, with smooth surfaces that resist stains and odors, maintaining hygiene and a pristine appearance over time.

Energy efficiency is a hallmark of the Whirlpool brand, and the W10196160D is no exception. It meets rigorous energy-saving guidelines, which not only reduces environmental impact but also leads to lower utility bills. The appliance operates quietly, allowing you to enjoy conversations in your kitchen without disruptive noises.

Another feature of the Whirlpool W10196160D is its intuitive control panel. It features simple touch controls that enable users to easily adjust settings and monitor cooking progress. The clear display provides all necessary information at a glance, making it perfect for those who may not be tech-savvy.

Safety is also a primary consideration in the design of the W10196160D. It comes equipped with child lock features, ensuring that the appliance remains secure and functions safely in homes with young children. Additionally, its durable construction is designed to withstand the rigors of everyday use.

In summary, the Whirlpool W10196160D is an impressive appliance characterized by its smart technology, large capacity, energy-efficiency, user-friendly interface, and enhanced safety features. This makes it an ideal addition to any kitchen, combining function with style while delivering exceptional cooking results.
Top Page Image Contents