Whirlpool W10196160D Electrical Requirements, Gas Supply Requirements, Type of Gas

Page 5

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.

This range is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided.

■Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded.

■The wiring diagram is located on the underside of the storage drawer or below the warming drawer in a clear plastic bag.

NOTE: The metal chassis of the range must be grounded in order for the control panel to work. If the metal chassis of the range is not grounded, no keypads will operate. Check with a qualified electrician if you are in doubt as to whether the metal chassis of the range is grounded.

Gas Supply Requirements

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition or CAN/CGA B149 - latest edition.

IMPORTANT: Leak testing of the range must be conducted according to the manufacturer’s instructions.

Type of Gas

Natural gas:

This range is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas.

■This range is factory set for use with Natural gas. See “Gas Conversions” section. The model/serial rating plate located behind the storage drawer on the right-hand side oven door frame has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier.

LP gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. See “Gas Conversions” section.

Gas Supply Line

■Provide a gas supply line of ¾" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size can be ½" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and materials used in the system.

NOTE: Pipe-joint compounds that resist the action of LP gas must be used. Do not use TEFLON®† tape.

Flexible metal appliance connector:

■If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152.4 cm) long, ½" (1.3 cm) or

¾" (1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line.

■A ½" (1.3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator.

■Do not kink or damage the flexible metal tubing when moving the range.

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Range Safety Instructions D’INSTALLATION DES Cuisinières À GAZWhat to do if YOU Smell GAS Location Requirements Installation RequirementsTools and Parts Cabinet Dimensions Product DimensionsGas Supply Requirements Electrical RequirementsType of Gas Gas Supply LineUnpack Range Gas Supply Pressure TestingGas Pressure Regulator Burner Input RequirementsTypical rigid pipe connection Install Anti-Tip BracketMake Gas Connection Typical flexible connection Verify Anti-Tip Bracket LocationComplete Connection Plug into a grounded 3 prong outletElectronic Ignition System Level RangeAdjust Oven Broil Burner Flame if needed Adjust Oven Bake Burner Flame if neededReplace Oven Racks Warming Drawer Check Operation of Oven Broil BurnerIf you need Assistance or Service Complete InstallationStorage Drawer To RemoveLP Gas Conversion GAS ConversionsTo Convert Gas Pressure Regulator To Convert Surface BurnersTo Convert Oven Broil Burner Complete InstallationTo Convert Oven Bake Burner Natural Gas Conversion Stamped number Votre sécurité et celle des autres est très importante Sécurité DE LA CuisinièreOutillage et pièces Exigences D’INSTALLATIONEmplacement d’installation Dimensions du placard Dimensions de lappareilSpécifications de l’alimentation en gaz Spécifications électriquesType de gaz Gaz naturelDétendeur Canalisation dalimentation en gazDébit thermique des brûleurs Tests de pressurisation de la canalisation de gazInstallation de la bride antibasculement Instructions DinstallationDéballage de la cuisinière Sur les cuisinières équipées d’un tiroir de remisageRaccordement à la canalisation de gaz Déplacer la cuisinière vers son emplacement final enRaccordement typique à une canalisation rigide Sous la cuisinièreMise à niveau de la cuisinière Vérification de lemplacement de la Bride antibasculementRaccordement typique par raccord flexible Compléter le raccordementAllumage initial et réglages des flammes Système dallumage électroniqueSi le brûleur ne sallume pas correctement Réglage de la taille des flammesPour ôter le répartiteur de flammes Contrôle du fonctionnement du brûleur du grilUtilisation dun miroir Sil est nécessaire de régler la taille des flammesTiroir De Remisage Réinstallation des grilles du four et du Tiroir-réchaudAchever l’installation Conversion du détendeur Conversions Pour Changement DE GAZConversion de Gaz naturel à Propane Ôter les grilles du four Conversion des brûleurs de la table de cuissonConversion du brûleur du four Conversion du brûleur du gril Achever linstallationConversion de Propane à Gaz naturel Marquage didentification Conversion du brûleur du four W10196160D

W10196160D specifications

The Whirlpool W10196160D is a cutting-edge appliance designed to enhance the functionality and efficiency of modern kitchens. This product is particularly known for its reliability and user-friendly features, making it a preferred choice for homeowners and culinary enthusiasts alike.

One of the standout features of the Whirlpool W10196160D is its advanced technology that ensures optimal performance. The appliance incorporates Smart Sensor technology, allowing it to automatically detect the proper cycle settings based on the type of food being cooked. This innovative feature helps in achieving perfect cooking results every time while minimizing energy usage.

The W10196160D also boasts a spacious capacity, accommodating large meals and multiple dishes simultaneously. This is particularly beneficial for families or those who frequently entertain guests. The interior design is engineered for easy cleaning, with smooth surfaces that resist stains and odors, maintaining hygiene and a pristine appearance over time.

Energy efficiency is a hallmark of the Whirlpool brand, and the W10196160D is no exception. It meets rigorous energy-saving guidelines, which not only reduces environmental impact but also leads to lower utility bills. The appliance operates quietly, allowing you to enjoy conversations in your kitchen without disruptive noises.

Another feature of the Whirlpool W10196160D is its intuitive control panel. It features simple touch controls that enable users to easily adjust settings and monitor cooking progress. The clear display provides all necessary information at a glance, making it perfect for those who may not be tech-savvy.

Safety is also a primary consideration in the design of the W10196160D. It comes equipped with child lock features, ensuring that the appliance remains secure and functions safely in homes with young children. Additionally, its durable construction is designed to withstand the rigors of everyday use.

In summary, the Whirlpool W10196160D is an impressive appliance characterized by its smart technology, large capacity, energy-efficiency, user-friendly interface, and enhanced safety features. This makes it an ideal addition to any kitchen, combining function with style while delivering exceptional cooking results.
Top Page Image Contents