Whirlpool W10531342A installation instructions Level Range, Installing/Replacing the Battery

Page 10

6.Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket.

If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, to contact service.

Level Range

1.Place a standard flat rack in oven.

2.Place level on the rack and check levelness of the range, first side to side; then front to back.

3.If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket.

4.Use a ³⁄₈" drive ratchet and slip-joint pliers to adjust leveling legs up or down until the range is level.

5.Push range back into position.

6.Check that rear leveling leg is engaged in the anti-tip bracket.

NOTE: Range must be level for satisfactory baking performance.

Installing/Replacing the Battery

A

A. Battery holder location

A

B

C

D

A.Screw

B.Metal battery top*

C.Plastic battery box

D.Battery holder

*NOTE: Metal battery top is included in the bag containing literature.

To install or replace the 9V DC alkaline battery, follow the steps below.

1.Open the broiler door.

2.Remove broiler pan and grill from broiler.

3.Using a Phillips screwdriver, remove the metal battery top from the bottom of the range and open the plastic battery box.

10

Image 10
Contents Installation Instructions 20 50.8 CM Freestanding GAS Range Range Safety Your safety and the safety of others are very importantAnti-Tip Bracket Range Foot Tools and Parts Installation RequirementsLocation Requirements Cabinet Dimensions Mobile Home Additional Installation RequirementsProduct Dimensions Freestanding Range Mobile home installations requireGas Supply Line Gas Supply RequirementsType of Gas Gas Pressure RegulatorGas Supply Pressure Testing Installation InstructionsInstall Anti-Tip Bracket Unpack RangeTypical flexible connection Make Gas ConnectionTypical rigid pipe connection Floor MountingVerify Anti-Tip Bracket Is Installed Engaged Complete ConnectionInstalling/Replacing the Battery Level RangeElectronic Ignition System Battery Status IndicatorInitial lighting and gas flame adjustments While a knob is Then Lite position, ifCheck Operation of Cooktop Burners If the low flame needs adjustingIf the flame needs adjusting Check Operation of Oven/Broil BurnerIf you need Assistance or Service Complete InstallationIf range does not operate, check the following LP Gas Conversion GAS ConversionsTo Convert Gas Pressure Regulator To Convert Surface Burners Natural Gas Conversion Complete ConversionTo Convert Oven Burner Turn the cap over so that N or NAT is visible Natural gas oven orifice spud stamped with Page W10531342A