Whirlpool W10531342A GAS Conversions, LP Gas Conversion, To Convert Gas Pressure Regulator

Page 14

GAS CONVERSIONS

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer.

LP Gas Conversion

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

To Convert Gas Pressure Regulator

1.Turn manual shutoff valve to the “closed” position.

B

A

C

A. Gas supply line

B. Manual shutoff valve “closed” position

C. To range

2.Unplug range or disconnect power.

3.Open broiler door and remove broiler pan. The gas pressure regulator is located in the back right hand corner of the broiler compartment.

A

A. Gas pressure regulator

IMPORTANT: Do not remove the gas pressure regulator.

14

Image 14
Contents Installation Instructions 20 50.8 CM Freestanding GAS Range Range Safety Your safety and the safety of others are very importantAnti-Tip Bracket Range Foot Location Requirements Installation RequirementsTools and Parts Cabinet Dimensions Mobile Home Additional Installation RequirementsProduct Dimensions Freestanding Range Mobile home installations requireGas Supply Line Gas Supply RequirementsType of Gas Gas Pressure RegulatorGas Supply Pressure Testing Installation InstructionsInstall Anti-Tip Bracket Unpack RangeTypical flexible connection Make Gas ConnectionTypical rigid pipe connection Floor MountingVerify Anti-Tip Bracket Is Installed Engaged Complete ConnectionInstalling/Replacing the Battery Level RangeElectronic Ignition System Battery Status IndicatorInitial lighting and gas flame adjustments While a knob is Then Lite position, ifCheck Operation of Cooktop Burners If the low flame needs adjustingIf the flame needs adjusting Check Operation of Oven/Broil BurnerIf range does not operate, check the following Complete InstallationIf you need Assistance or Service To Convert Gas Pressure Regulator GAS ConversionsLP Gas Conversion To Convert Surface Burners To Convert Oven Burner Complete ConversionNatural Gas Conversion Turn the cap over so that N or NAT is visible Natural gas oven orifice spud stamped with Page W10531342A