3.Use a combination wrench and pliers to attach the flexible connector to the adapters. Check that connector is not kinked.
A
B
D
C
6.Remove cooktop burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Place burners, burner caps and grates on the cooktop.
Verify Anti-Tip Bracket Is Installed and
Engaged
1. Place the outside of your foot against the bottom front of the |
broiler, and grasp the lower right or left side of the control |
panel as shown. |
A. Pressure regulator connection fitting
B. Use
C.Adapter
D.Flexible connector
E 
F
G
H
E.Adapter
F.Use
G.Manual shutoff valve
H.½" or ¾" gas pipe
NOTE: If your countertop is mounted with a backsplash, it |
may be necessary to grasp the range higher than is shown in |
the illustration. |
Complete Connection
1.Locate gas pressure regulator in the broiler.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
2.Check that the gas pressure regulator shutoff valve is in the “ON” position.
Front View | Front | Side View |
| ||
Shutoff valve |
| “ON” Position |
3.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
4.Test all connections by brushing on an approved noncorrosive
5.Close the broiler door.
2.Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is engaged in the
3.If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, stop tilting the range and lower it gently back to the floor. The range foot is not engaged in the
IMPORTANT: If there is a snapping or popping sound when lifting the range, the range may not be fully engaged in the bracket. Check to see if there are obstructions keeping the range from sliding to the wall or keeping the range foot from sliding into the bracket. Verify that the bracket is held securely in place by the mounting screws.
4.Slide the range forward, and verify that the
5.Slide range back so the rear range foot is inserted into the slot of the
IMPORTANT: If the back of the range is more than 2" (5.1 cm) from the mounting wall, the rear range foot may not engage the bracket. Slide the range forward and determine if there is an obstruction between the range and the mounting wall. Changes to the gas supply must be performed by a qualified service technician. If you need assistance or service, refer to the “Assistance or Service” section of the Use and Care Guide for contact information.
9