6.After cleaning the gas tube opening and ports, replace the burner cap and pan. (Burner pan must be replaced over burner base before replacing burner cap. Do not operate burners without burner pans in place.) To replace burner cap, make sure cap is properly aligned and leveled. Find the recessed locating tabs on the burner cap (see illustration) and place cap over the white ignitor in the burner base.
7.Turn on the burner to determine if it will light. If the burner does not light after cleaning, contact an authoriied Whirlpool’ service technician. Do not service the sealed burner yourself.
Removing the oven door
Removing the oven door will help make it easier to clean the oven.
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the oven is cool before removing oven door.
Failure to do so could result in burns or electrical shock.
To remove:
1.Open the door as far as it will go.
2.Remove the screws on each side of the oven door.
3.Close the door about ?4 of the way.
4.Lift the door up and off the hinges.
| _ |
|
| ||
|
|
| . |
| |
|
|
|
|
| |
4Q |
|
|
|
|
|
|
|
| i |
|
|
| / | /.’ | m |
|
|
|
| ::: | ’ | screw | |
|
| ...... |
| ||
| ....... |
|
|
| |
| ........ |
| 0 |
| |
| ........ |
|
| ||
......... |
|
| |||
/ | ........ |
|
|
| |
:.Y |
|
|
| ‘A |
|
|
|
|
|
| |
& |
|
|
| 7 |
|
19