Adjusting the oven temperature
Oven temperature controls will gradually shift after years of use. So, even though your new oven is properly adjusted to provide accurate temperatures, it may cook faster or slower than your old oven.
If, after using the oven for a period of time, you are not satisfied with the temperature settings, you can adjust them by following these steps:
1.Make sure the Oven Temperature Control Knob is turned to the off position. Pull knob straight off and flip it over.
2.Loosen the locking screws inside the control knob. Note the position of the notches.
3.To lower the temperature, hold knob handle firmly and move the tooth a notch clockwise. Each notch equals about
20°F (11%).
4.To raise the temperature, hold knob handle firmly and move the tooth a notch
counterclockwise. Each notch equals about 20°F (11 “C).
5.Tighten the locking screws and replace the control knob.
Broiling
The broiler drawer is located below the oven door. Always broil with the oven door closed.
1. Pull the broiler drawer open and tilt the door panel down.
2. Place broiler pan grid so grease can drain down ribbing and through slots into lower part of the broiler pan. See picture.
Drain slot
3.Before the broiler is turned on, place food on broiler pan and position the broiler pan at one of the three levels.
control
To lower
RibFront
4. Close broiler drawer.