Storage Drawer
The storage drawer can be removed. Before removing, make sure drawer is cool and empty.
To Remove:
1.Pull the storage drawer straight back past the drawer stop notch and the end of the side rails
2.Lift up the front of the drawer to a level position.
3.Slowly push the drawer into the range until the drawer side rails engage with the gap in the drawer glides.
A
A B
A. Drawer stop notch
B. End of side rail
2.Lift up the back of the drawer and pull the drawer out.
A. Engage drawer glide
4.Once the drawer is fully engaged on both sides, slide the drawer back into the closed position.
NOTE: When removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides.
To Replace:
1.Lift up the back of the drawer and place it inside the range in its fully forward position.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate |
| Cooktop cooking results not what expected |
■Is the power supply cord unplugged? Plug into a grounded outlet.
■Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
Cooktop will not operate
■Is the control knob set correctly? Push in knob before turning to a setting.
■On ceramic glass models, is the “Cooktop Lockout” set? See “Cooktop Lockout” section.
■On coil element models, is the element inserted properly? See “Coil Elements and Burner Bowls” section.
Excessive heat around cookware on cooktop
■Is the cookware the proper size?
Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.
■Is the proper cookware being used? See “Cookware” section.
■Is the control knob set to the proper heat level? See “Cooktop Controls” section.
■Is the appliance level?
Level the appliance. See the Installation Instructions.
■On coil element models, is the element inserted properly? See “Coil Elements and Burner Bowls” section.
Oven will not operate
■On some models, is the electronic clock/timer set correctly?
See “Electronic Clock/Timer” section.
■On some models, has the oven selector been set to a BAKE or BROIL function?
See “Baking and Roasting” or “Broiling” sections.
Oven temperature too high or too low
■Does the oven temperature calibration need adjustment? See “Oven Temperature Control” section.
Hot Surface indicator light stays on
■Does the Hot Surface indicator light stay on after control knob(s) have been turned off?
See “Cooktop Controls” section.
Oven indicator lights flash
■Do the OVEN HEATING indicator lights flash? See “Assistance or Service” section.
14