RADIO RECEPTION pg. 8
MANUAL TUNING
1 Press TUNER/BAND repeatedly to select the desired band.
When TUNER/BAND is pressed while the power is off, the previously tuned station will be played (Direct Play Function).
To select a band with the remote control
Press BAND repeatedly.
2 Press 
or 
to select a station.
Each time the button is pressed, the frequency changes. When a station is received, "TUNE" is displayed for 2
seconds. During FM stereo reception, "
"is displayed.
To search for a station quickly (Auto Search)
Keep 
or 
pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press 
or 
.
• The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MODE on the remote control so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press MODE so that "MONO" disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.
Press POWER while pressing 
DIR/ PRESET during power on.