Aiwa XR-M55 operating instructions Timer Recording

Page 28

3 Press or to select a source, then press ENTER.

If TUNER is pressed, the band cannot be s elected in this step.

MULTI JOG is also available instead of and .

After you select a source, the duration for the timer-activated period flashes on the display.

4 Select the duration for the timer-activated period with or , then press ENTER.

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

• MULTI JOG is also available instead of and .

5 Prepare the source.

To listen to a CD, load the disc.

To listen to a tape, insert the tape into deck.

To listen to the radio, tune in to a station.

6 Press POWER to turn the unit off after adjusting the volume and tone.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

The volume level is automatically set to 20 when the power is turned off with the volume level set to 21 or more.

To check the specified time and source

Press JOG MODE repeatedly until "¥" is displayed. The timer-on time, the selected source name and the duration for the timer-activated period flash alternately for 6 seconds.

To cancel timer standby mode temporarily

Press JOG MODE repeatedly until "¥" is displayed, then turn MULTI JOG within 6 seconds until "¥" or "¥ REC" disappears on the display.

To restore the timer standby mode, press JOG MODE repeatedly until "¥" is displayed, then turn MULTI JOG within 2 seconds to display "¥" or "¥REC".

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

Timer playback and timer recording will not begin unless the power is turned off.

Connected equipment cannot be turned on and off by the built-in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press JOG MODE repeatedly until "¥" is displayed, then turn MULTI JOG within 2 seconds until "¥REC" appears on the display. Then press ENTER within 6 seconds.

Carry out the steps of "SETTING THE TIMER" from step 2 and insert the tape to be recorded into deck after step 5.

 

 

 

 

 

OTHER CONNECTIONS

pg. 17

 

 

 

 

 

Image 28
Contents Aiwa Call toll free 1-800-BUY-AIWAPrecautions InstallationElectric Power AC power cordPrecautions cont pg Table of ContentsCheck your system accessories Before connecting the AC cordPreparations pg ConnectionsPreparations cont pg Connect the right speaker to the main unitConnect the left speaker to the main unit Connect the supplied antennasTo position the antennas FM feeder antenna AM loop antennaConnecting AN Outdoor Antenna Remote ControlTo turn the power off Demo Demonstration modeTo cancel Demonstration mode Before OperationSetting ECO Power Economizing Mode Using the headphonesPress DEMO/ECO To change the brightness of the displayAudio Adjustments VolumeSound pg Super T-BASS SystemTo select with the remote control To cancel the selected modeGraphic Equalizer Manual Tuning Radio Reception pgPresetting Stations Preset Number TuningSelecting a preset number on the main unit Repeat steps 1CD Playing pg Basic OperationsLoading Disc Playing DiscCD Playing RANDOM/REPEAT PlayProgrammed Play Tape Playback pg To select a reverse mode Inserting a TapePlaying Back a Tape Insert a tape. Then press to start playRecording pg To change the playback side, pressTo fast forward or rewind, press To set the tape counter toPress TAPE/REV Mode to select the reverse mode Basic RecordingPreparation Insert the tape to be recorded on into deckSound adjustment during recording Recording contpgInserting Blank Space AI Edit RecordingInsert the tape into deck Press numbered buttons 0-9 to designate the tape lengthTo stop recording To clear the edit programProgrammed Edit Recording Time on cassette tapes and editing timeAfter confirming B on the display, repeat step Clock and Timer pg Setting the ClockTo change the program of each side Press To designate the time, then pressTo switch to the 24-hour standard Setting the Sleep TimerIf the clock display flashes Clock and Timer cont. pg Setting the TimerTo check the time remaining until the power is turned off To cancel the sleep timerTimer Recording Connecting Optional Equipment VIDEO/AUX JacksMD Jacks Line OUT JacksGeneral pg Care and MaintenanceListening to External Sources Troubleshooting Guide To demagnetize the headsCare of discs Care of tapesSpecifications General cont pgFM tuner section AM tuner sectionAmplifier section Cassette deck sectionGeneral cont. pg Parts Index