Eurocave 25, 50 installation instructions Installing the Conditioner, General points

Page 9

7 - INSTALLING THE CONDITIONER

I - General points

-If the power lead is damaged, it must be replaced by a quali￿ed electrician.

-Never damage the appliance’s refrigerating circuit.

Your conditioner’s power lead is supplied without a plug. “Fitting a power plug or connecting the conditioner to a junction box must be carried out by a quali￿ed electrician.

In all cases, connection of your conditioner must be carried out on an earthed socket to prevent any risk of electric shock.

230V-13A* earthed power outlet with di￿erential circuit breaker (30mA*) protected by a fuse. *not valid for some countries

IMPORTANT : any electrical work must be carried out by a quali￿ed electrician. Power outlet not valid for some countries.

Electric connection must be carried out by means of a device to ensure isolation from the mains system. The isolating device should open all of the contacts of all the poles ensuring complete disconnection in line with the conditions in over-voltage category III. Installation must be carried out in compliance with national installation

regulations.Ventilated room

• Positioning your conditioner:

 

 

 

 

CELLAR

 

 

 

 

 

 

 

 

 

The conditioner produces cold air inside the cellar and expels hot air outside (see diagram A).

 

 

 

 

 

 

 

- Do not install the conditioner facing the door of the room (risk of condensation on the door joints).

Temperature:

 

 

 

 

- Do not place the external section of the conditioner above a source of heat.

 

 

 

 

Max.: 35°C

 

 

 

 

- For insulation reasons, there must be no windows or bay windows in the room to be conditioned.

Min.: -5°C

 

 

 

 

- No piped hot water must pass through the room to be conditioned (e.g. under-￿oor heating).

 

 

 

 

 

 

 

- Is it not better to state that pipes with hot water must be insulated so that there is no heat loss?

 

 

 

 

 

 

 

- The exterior of the conditioner must not be located in an area subject to atmospheric exposure.

Diagram A

 

 

 

 

- No heat-producing appliance must be located in the area to be conditioned (e.g. refrigerator, radiator, boiler).

 

 

 

 

 

 

 

 

 

 

 

- Do not obstruct the air entry and exit points.

 

 

 

 

 

 

 

 

 

 

Bottles

 

 

- Never place a container or object containing liquid on top of the conditioner.

 

 

 

 

 

 

 

-The room where the hot air is expelled must, ideally, be approximately twice as large as the wine cellar and well

 

 

 

 

CELLAR

 

 

ventilated so that the hot air can be properly expelled.

 

 

 

 

 

 

 

 

 

 

 

 

 

- Wait 48 h before plugging in so that the ￿uids in the internal circuits can settle.

 

 

 

 

 

 

 

- Never connect several conditioners to a multi-socket.

 

Door

Conditioner

 

 

• Recommendations:

 

 

 

 

CELLAR

 

 

- Fit your conditioner as close as possible to the ceiling in order to ensure uniform dispersal of cold air in the

 

 

 

 

 

Bottles

 

 

 

 

 

 

 

cellar.

 

Door

 

 

 

 

 

 

 

 

 

-We recommend that you leave a space of 200 mm between the ceiling and conditioner housing to make it easier

 

Conditioner

 

 

to ￿t the appliance onto its base.

 

 

Conditioner

 

 

 

 

 

 

- Air outlets (hot and cold) must not be obstructed by any obstacles (minimum distance: 1500 mm).

 

 

 

 

 

 

 

Direct the cold air outlet so it is facing the bottles (see diagram D).

 

 

 

 

CELLAR

 

Bottles

 

 

 

 

 

 

 

• Installation: (see B diagrams)

 

 

 

 

 

 

 

The conditioner was designed to be completely modular and adapt to any type of cellar.

Diagram D

 

Door

 

 

You can, amongst other options, install it either outside or inside your cellar, position it close to the ￿oor (￿xed to the wall) or at a height (we recommend, however, installing it at a height for improved air convection).

Additionally, hot air can be expelled from di￿erent angles (to be speci￿ed when ordering): facing forwards, right or left.

You also have the option of expelling hot air outside the room by way of extractor piping (standard piping, 160 mm in diameter, not supplied). Finally, you can choose to ￿t the conditioner onto a door.

Conditioner housed inside the cellar with extraction facing forwards / aesthetic front panel on the outside

Cold air discharged

Hot air expelled

Diagram B

Hot air expelled

Diagram B

Cold air discharged

Conditioner housed outside the cellar with extraction facing forwards / aesthetic front panel on the inside

Conditioner housed outside the cellar with extraction on the left side / aesthetic front panel on the inside.

Diagram B

Diagram B

4

Conditioner housed inside the cellar, GB ￿tted onto an adapted door.

9

Image 9
Contents March Contents Servic E DU VIN AU Verre Welcome to the World of Eurocave Usual wine serving temperaturesHOT AIR Conditioner DescriptionElectrical Power Supply Technical Specifications Insulation boards dierent methods of tting are possible Insulate yes but how?General points Installing the ConditionerIII- Fitting II- Drilling the wallPage Fitting close to the floor Fitting onto a doorConditioner with air extraction via piping Conditioner housed outside the cellarConditioner housed inside the cellar IV- Discharging condensateConditioner Operation Installing the Remote Control Remote control descriptionII- Installing the remote control inside the cellar Connecting the sensor to the remote control III- Installing the remote control outside the cellarFitting Programming the remote controlII- Switching on III- Remote control descriptionOnnection Setting the temperature IV- Installing the remote controlVI- Silent function VIII- C hanging the remote control batteriesVII- Heating function IX Discharging condensateOperating Faults Maintenance12 GB Around Wine

25, 50 specifications

The Eurocave 50,25 is a premium wine cellar designed for both wine enthusiasts and collectors, providing an optimal storage solution to preserve and enhance the quality of fine wines. With a sleek and stylish design, this model not only serves a functional purpose but also adds a touch of elegance to any interior space.

One of the standout features of the Eurocave 50,25 is its capacity. It can accommodate up to 50 bottles, making it suitable for both moderate and larger collections. The cellar is designed to store your bottles horizontally, ensuring that the corks remain moist and preventing oxidation. This thoughtful design helps maintain the wine's integrity over time, ensuring that each bottle is ready to be enjoyed when the time comes.

The Eurocave 50,25 is equipped with advanced temperature control technology, allowing users to set and maintain the perfect storage conditions for their wines. With a temperature range of 5 to 20 degrees Celsius, this wine cellar is highly versatile, catering to the needs of different wine types, including reds, whites, and sparkling wines. The cellar features precise electronic controls that ensure consistent temperatures, eliminating the risk of detrimental fluctuations.

Moreover, the Eurocave 50,25 employs a dual-zone cooling system, which enables the separation of storage environments within the cellar. This feature allows wine enthusiasts to store various types of wines at their ideal temperatures simultaneously, catering to a diverse collection.

Another significant characteristic of the Eurocave 50,25 is its humidity control technology. Maintaining optimal humidity levels is crucial to prevent cork deterioration and evaporation of wine. This wine cellar features a built-in humidification system, ensuring a stable level of humidity around 50-80%, which is ideal for wine storage.

In addition to its functional features, the Eurocave 50,25 is designed with aesthetic appeal in mind. The unit comes with a sleek, contemporary design and soft interior lighting, allowing users to display their wine collection attractively. The insulated glass door provides visibility while protecting the bottles from harmful UV rays.

Overall, the Eurocave 50,25 combines state-of-the-art technologies with an elegant design, making it an ideal choice for serious wine collectors and casual enthusiasts alike, who value quality storage and display solutions for their prized wine selections.