REPEAT
cPLAY
aPAUSE
r, t
sSTOP
PROGRAMMED PLAY
Up to 30 tracks can be programmed from the disc.
1 In stop mode, keep * sMEMORY pressed until “M” flashes in the display.
* or s STOP on the remote control
2 Press ror tto select a track, then press sMEMORY to store it.
Track number
Programmed number
To select a track with the remote control
Press the numbered buttons
3 Repeat step 2 to program other tracks.
4 Keep s MEMORY pressed until “M” stops flashing to finish the program.
“M” remains displayed and indicates the unit stores the programmed tracks.
5 Press e to start play.
To check the program, press r or t in stop mode.
To clear the program, press sonce in stop mode so that “M” disappears in the display.
To change the programmed tracks, clear the program and repeat all the steps again.
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
1 Keep REPEAT/SLEEP/FM MODE/OSC pressed until “30” flashes in the display.
2 Within 4 seconds, press ror tto specify the time until the power is turned off.
Each time it is pressed, the time changes between 10 and 90 minutes in
Specified time |
|
While the sleep |
|
timer works, the |
|
dot keeps flashing. |
|
To check the time remaining until the power | En |
is turned off |
|
Repeat step 1 shown above. The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press r or t repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, c on the deck will not be released. Press Z to release c.