Continental Refrigerator 20, 22 installation instructions Troubleshooting Tips, Consumer Support

Page 4

Safety Instructions

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING!

HOW TO CONNECT ELECTRICITY

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly grounded.

Instructions Operating Instructions

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating plate.

This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires.

Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.

Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.

When moving the refrigerator away from the wall, be careful not to roll over or damage the power cord.

Installation

USE OF ADAPTER PLUGS (Adapter plugs not permitted in Canada)

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an adapter plug.

Troubleshooting Tips

However, if you must use an adapter, where local codes permit, a temporary connection may be made to a properly grounded 2-prong wall outlet by use of a UL-listed adapter available at most local hardware stores.

The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord.

When disconnecting the power cord from the adapter, always hold the adapter in place with one hand while pulling the power cord plug with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.

If the adapter ground terminal breaks, DO NOT USE the refrigerator until a proper ground has been established.

Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Consumer Support

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents 3828JL8012A 197D4618P002 49-6028205-03 JR Write the model and serial numbers here Model # Serial #Safety Precautions Refrigerants Before You Throw Away Your Old Refrigerator or FreezerGEAppliances.com Troubleshooting Tips Consumer SupportChanging the Temperature About the controls withTips Consumer Support Performance Air Flow SystemAbout the controls with numbered settings When to Replace the Filter Installing the Filter CartridgeAbout the water filter. on some models Water Filter CartridgeAbout the shelves and bins Rearranging the ShelvesSpillproof Shelves on some models To removeAbout the additional features SafetyAdjustable Bins on the Door Non-Adjustable Shelves on the DoorInstructions Operating Instructions Safety Instructions About the crispers and pansAbout the freezer InstructionsFreezer Shelves and Baskets Basket/Shelf RemovalIcemaker Accessory Kit Tips InstallationAbout the automatic icemaker Cleaning the Outside Care and cleaning of the refrigeratorCleaning the Inside Preparing for Vacation Behind the RefrigeratorPreparing to Move Refrigerator Lights Replacing the light bulbsFreezer Light Preparation Before YOU BeginTools YOU MAY Need Refrigerator Location ClearancesTurn on the Water Supply Plug in the RefrigeratorAttach Refrigerator Door Handle Attach Freezer Door Handle Level the RefrigeratorSET the Controls Start the IcemakerRemove the Drawer Front from the Slides Remove the BasketRemove the Leveling Legs Replace the Freezer Basket Attach and Secure the Drawer Front to the SlidesImportant Notes Tools YOU will NeedRemove the Freezer Door Remove the Center Hinge PINRemove Center Hinge Installation Instructions Reversing the Door Swing Transfer Freezer Door StopInstall Center Hinge PIN Install Center HingeHang the Freezer Door Transfer Refrigerator Door Handle to Right Rehang Refrigerator Door Installing the Water Line Icemaker Models What YOU will NeedChoose the Valve Location Shut OFF the Main Water SupplyDrill the Hole for the Valve Fasten the Shutoff Valve Tighten the Pipe ClampConnect the Tubing To the Valve Route the TubingBefore you call for service… Normal operating soundsInstructions Safety General Electric Company Consumer Product Ownership Registration Customer Warranty GE Will Replace What GE Will Not CoverOne Year Thirty DaysPerformance Data Sheet Operating SpecificationsGeneral Installation/Operation/Maintenance Requirements Special NoticesWater Treatment Device Schedule Service Consumer Support

22, 20 specifications

The Continental Refrigerator 20 and 22 series are sophisticated commercial refrigerator units designed to meet the rigorous demands of food service operations. Known for their reliability and robust construction, these models are ideal for restaurants, catering services, and other establishments requiring efficient temperature control and food preservation.

One of the standout features of the Continental Refrigerator 20 and 22 models is their exceptional cooling technology. These units are equipped with a powerful refrigeration system that ensures rapid cooling and consistent temperature management. With digital thermostats and automatic defrosting capabilities, they maintain optimal internal conditions, reducing the risk of temperature fluctuations that can compromise food safety.

The design of the units focuses on energy efficiency, which is critical in today’s eco-conscious market. Both the 20 and 22 models utilize high-efficiency refrigeration components and insulating materials that minimize energy expenditure without sacrificing performance. They also comply with environmental regulations, ensuring that they are a responsible choice for any business.

In terms of storage space, these models boast generous capacities suitable for various types of food products. Adjustable shelving and interior LED lighting enhance visibility and accessibility, allowing staff to locate items quickly and efficiently. The stainless steel exterior adds strength and durability, while also providing an easy-to-clean surface that resists corrosion and damage from daily use.

The user-friendly design extends to the controls as well. The digital display allows for precise temperature adjustments and enables easy monitoring of internal conditions. Additionally, the units are equipped with self-closing doors that help maintain the internal climate while offering ergonomic access for staff.

Safety features are also emphasized in the Continental Refrigerator 20 and 22 models. The door gaskets are designed to create an effective seal, preventing cold air from escaping and ensuring energy efficiency. Moreover, these refrigerators are equipped with a wide range of safety alarms to alert users in case of temperature discrepancies or door malfunctions.

Overall, the Continental Refrigerator 20 and 22 series represent a blend of functionality, reliability, and user-centric design, making them a smart investment for any commercial kitchen looking to enhance their food preservation solutions. With their advanced features and durable construction, these refrigerators stand out as a preferred choice for food service professionals.
Top Page Image Contents