19.50

CLOCK/MINUTE MINDER OPERATION

0.00

1.41

Here you can set a time period of up to 10 hours, that will count down. When it reaches zero, the timer will emit an audible tone.

For Example: If you set 20 minutes, the audible tone will occur 20 minutes later.

SETTING THE MINUTE MINDER

Step 1 Ensure the time of day is set correctly.

Step 2 Press and release the ‘+’ button.

Note: Step 3 must be started within 10 seconds, otherwise you must repeat Step 2.

Step 3 Press the ‘+’ button to set the required time period. A ‘Bell’ symbol will light up.

The time period can be adjusted, by using the ‘+’ button to increase the time period or the ‘-’ button to decrease the time period.

Release all buttons, the timer display will show the remaining time period. The ‘Bell’ symbol will remain lit to signify that a time period has been set.

At the end of the set time an audible tone will be heard and the ‘Bell’ symbol will disappear.

Step 4 To cancel the audible tone press the ‘+’ button.

To cancel the minute minder period press the ‘-’ button until 0.00 is displayed in the window then press the ‘+’ button.

If at any time the display shows flashing zero’s, it is likely that the electricity supply has been interrupted.

Reset the timer to the correct time of day.

Note: The Timer display will show the minute minder period as follows:

Any period up to 99 minutes and 50 seconds -

The display shows MINUTES and SECONDS (10s intervals) eg. 19 minutes 50 seconds

Any period between 100 minutes (1 hour 40 minutes) and up to 10 hours -

The display shows HOURS and MINUTES eg. 1 hour 41 minutes