Danby DWC518BLS owner manual Preparing the Enclosure, Fig E

Installation Instructions - Intergrated Application

Tools you will
Need
		Safety Glasses	Level
			Gloves
FOR YOUR SAFETY:
While performing installa-			Flashlight
tions described		in this	Carpenters
section,	gloves,	safety	Square
glasses or goggles should			Measuring
			Tape
be worn.
		Drill & Hole Saw set

Preparing the Enclosure

Electrical

Requirements:

The appliance must be connected to an individual properly grounded electri- cal outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.

•It is recommended that you do not install the wine cooler into a corner (i.e. directly beside a wall). This is to allow the door to have a greater then 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket.

•The rough cabinet opening must be on a level floor area and at least 24” deep by 24” wide. The opening should also have a height of at least 34 3/4”.

•The electrical oulet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig E).

•If the electrical outlet is locat- ed inside the adjacent cabi- netry, cut a 1-1/2” diameter hole to admit the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.

34 3/4”

From

Underside

of

Countertop

to Floor

1-1/2” dia. hole *if electical outlet is in adjacent

cabinetry 24”

Min.

2”

Electrical Access

6”

24”

Cabinets

Square

and

Plumb

Fig E

8