Install properly... | Remove sales labels... |
| Remove the Consumer Buy Guide label, tape |
| and any lnslde labels before using the re- |
| frigerator. To remove any remalnlng glue: |
| 1. Rub briskly with thumb to make a ball then |
| remove. |
| OR |
| 2. Soak area with liquid hand dishwashing |
| detergent before removing glue as described |
| in step 1. |
| DO NOT USErubblng alcohol or flammable or |
| toxic solvents, such as acetone, gasoline, car- |
| bon tetmchlorlde, etc. These can damage the |
| material. |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- |
| STRUCTIONS LABELS INSIDE YOUR REFRIGER- |
| ATOR. |
| Do not remove the Tech sheet fastened under |
| the refrlgemtor at the front. |
1.Allow YZinch (1.25cm] space on each side and at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.
3.The refrigerator back can be flush against the wall.
Level refrigerator-freezer...
All’ USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
VELLING SCREW
1.Remove base grille (see page 7).
2.To raise front, turn screw in direction shown.
3.To lower front, turn screw in the direction shown,
4.Check with level.
Clean it...
Clean your refriger- 1 ator before using it.
See cleaning instruc- tions on page 8.
Plug- it in...
REFRIGERA;OR | ||
GROUNDING PLUG | ||
POWER CORD | ||
|
RECOMMENDED GROUNDING METHOD
A 115Volt, 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate cir- cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
4