Whirlpool GARAGE REFRIGERATOR manual Electrical Requirements, Refrigerator Doors

Page 5

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting.

Refrigerator Doors

TOOLS NEEDED: ⁵⁄₁₆" hex-head socket wrench, #2 Phillips screwdriver, flat-blade screwdriver, ⁵⁄₁₆" open-end wrench, flat 2" putty knife.

IMPORTANT:

■All graphics referenced in the following instructions are included later in this section after “Final Steps.” The graphics shown are for a right-hand swing door (hinges factory installed on the right).

■If you only want to remove and replace the doors, see the

“Remove Doors and Hinges” and “Replace Doors and Hinges.”

■Before you begin, turn the control OFF, and remove food and adjustable door or utility bins from doors.

Remove Doors and Hinges

⁵⁄₁₆" Hex-Head Hinge Screw

1.Unplug refrigerator or disconnect power.

2.Open refrigerator door and remove base grille from the bottom front of the refrigerator. See Base Grille graphic.

3.Close the refrigerator door and keep both doors closed until you are ready to lift them free from the cabinet.

NOTE: Provide additional support for the doors while the hinges are being moved. Do not depend on the door magnets to hold the doors in place while you are working.

4.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the freezer door free from the cabinet.

5.Remove the parts for the center hinge as shown in the Center Hinge graphic. Lift the refrigerator door free from the cabinet.

6.Remove the parts for the bottom hinge as shown in the Bottom Hinge graphic.

Reverse Doors (optional)

IMPORTANT: If you want to reverse your doors so that they open in the opposite direction, continue with “Reverse Doors (optional)” instructions. If you are not reversing the doors, see “Replace Doors and Hinges.”

Cabinet

1.Remove the ⁵⁄₁₆" hex-head hinge screws from handle side and move them to the opposite side. See Graphic 1-1.

2.Remove the cabinet hinge hole plugs from the cabinet top and move them to the opposite side hinge holes as shown in Graphic 1-2.

Doors

1.Remove the door hinge hole plugs from the top of the freezer and refrigerator doors. Move them to the opposite side as shown in Graphic 2.

2.Remove the door stops from both the freezer and the refrigerator doors and move them to the opposite side. See Graphic 3.

Replace Doors and Hinges

NOTE: Graphic may be reversed if door swing is reversed.

1.Replace the parts for the bottom hinge as shown and tighten screws. See Bottom Hinge graphic. Replace the refrigerator door.

NOTE: Provide additional support for the doors while the hinges are being moved. Do not depend on the door magnets to hold the doors in place while you are working.

2.Assemble the parts for the center hinge as shown and tighten all screws. See Center Hinge graphic. Replace the freezer door.

3.Assemble the parts of the top hinge as shown in the Top Hinge graphic. Do not tighten the screws completely.

4.Line up the doors so that the bottom of the freezer door aligns evenly with the top of the refrigerator door. Tighten all screws.

Final Steps

1.Check all holes to make sure that hole plugs and screws are in place. Reinstall top hinge cover. See Top Hinge graphic.

2.Replace the base grille. See Base Grille graphic.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

3.Plug into a grounded 3 prong outlet.

4.Reset the controls. See “Using the Controls.”

5.Return all removable door parts to doors and food to refrigerator.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Chillerator Garage Refrigerator Table DES Matières Table of ContentsÍndice Before You Throw Away Your Old Refrigerator or Freezer Refrigerator SafetyClean Before Using Installation InstructionsUnpack the Refrigerator Location RequirementsRefrigerator Doors Electrical RequirementsDoor Swing Reversal optional Caster Installation Adjust the DoorsDoor Closing Door AlignmentLower Rear Corner Complete the InstallationLower Front Corner Cleaning Using the ControlsRefrigerator USE Refrigerator CareRefrigerator Operation TroubleshootingChanging the Light Bulbs Temperature and Moisture Assistance or ServiceU.S.A CanadaGladiator Garageworks Major Appliance Warranty Antes de tirar su viejo refrigerador o congelador Seguridad DEL RefrigeradorDesempaque el Refrigerador Instrucciones DE InstalaciónRequisitos de localización Quitar los materiales de empaquePuertas del refrigerador Requisitos eléctricosMétodo de conexión a tierra recomendado Cómo quitar las puertas y las bisagrasPasos finales Cómo volver a poner las puertas y las bisagras en su lugarCómo quitar y volver a poner la puerta en su lugar Instalación de las ruedecillas Ajuste las puertasCierre de la puerta Alineamiento de la puertaComplete el la instalación Esquina inferior frontalEsquina inferior trasera Uso de los controles Cuidado DE SU RefrigeradorLimpieza Cómo ajustar los controlesFuncionamiento del refrigerador Solución DE ProblemasCómo cambiar los focos Temperatura y humedad Ayuda O Servicio TécnicoEn los EE.UU En CanadáGarantía Limitada DE UN AÑO Gladiator GarageworksAvant de jeter votre vieux réfrigérateur ou congélateur Sécurité DU RéfrigérateurExigences demplacement Instructions DinstallationDéballage du réfrigérateur Enlèvement des matériaux d’emballageSpécifications électriques Méthode recommandée de mise à la terrePortes du réfrigérateur Démontage Portes et charnièresInversion des portes facultatif Réinstallation Portes et charnièresÉtapes finales CaisseInversion du sens douverture de la porte option Ajustement des portes Installation des roulettesFermeture des portes Alignement des portesAngle inférieur/arrière Angle inférieur/avantAchever linstallation Utilisation des commandesAjustement des réglages de commandes Utilisation DU RéfrigérateurEntretien DU Réfrigérateur Remplacement des ampoules d’éclairageNettoyage Nettoyage de votre réfrigérateurFonctionnement du réfrigérateur DépannageTempérature et humidité Assistance OU ServiceGarantie Limitée DE UN AN Garantie DES Gros Appareils Ménagers Gladiator Garageworks2314467

GARAGE REFRIGERATOR specifications

The Whirlpool Garage Refrigerator is a versatile and reliable appliance designed to meet the unique demands of garage storage. This refrigerator is tailored for those who need additional cooling space without compromising on quality or functionality. One of its standout features is its temperature management system, enabling it to operate effectively in a broader range of ambient temperatures. Unlike standard refrigerators, this unit can function in extreme conditions, from as low as 0°F to as high as 110°F, making it perfect for unheated or insulated garages.

In terms of design, the Whirlpool Garage Refrigerator boasts a spacious interior layout, with adjustable shelving that allows users to customize storage according to their needs. The shelves are designed to accommodate taller items, and the door bins provide extra space for condiments and smaller containers. With a generous capacity, it ensures that there’s plenty of room for both beverages and food items.

Another innovative feature is the Energy Star certification, marking it as an energy-efficient choice that helps to save on electricity bills while being environmentally friendly. The intelligent design also includes an LED interior lighting system, which illuminates the interior without generating heat, allowing users to easily find items even in dimly lit garages.

Further enhancing its appeal are the frost-free cooling technology and organized space, which eliminates the build-up of frost, requiring less maintenance. With easy-to-use temperature controls located on the exterior, users can quickly adjust settings as needed without opening the door and losing cold air.

The Whirlpool Garage Refrigerator also stands out in terms of durability and build quality. Constructed with sturdy materials, it is designed to withstand the rigors of a garage environment. This appliance’s sleek exterior finish complements any garage décor, while its compact design makes it easy to fit into tight spaces.

In summary, the Whirlpool Garage Refrigerator combines functionality, adaptability, and energy efficiency, making it an ideal option for anyone needing additional cooling storage in their garage. With its thoughtful features and rugged construction, it is a reliable solution for keeping perishables fresh, beverages cold, and providing extra storage for various items. Whether for personal use or hosting gatherings, this refrigerator proves to be a valuable addition to any home.
Top Page Image Contents