To replace covers:
1.Fit cover frame notches into supports on walls of refrigerator.
2.Lower into place.
3.Slide back of crisper cover glass insert into place; then lower front.
Removing freezer trivet
(Model RSZOCK)
For proper air movement, keep freezer trivet in place when the refrigerator is operating.
To remove trivet:
1.Lift trivet up.
2.Pull trivet forward.
To replace trivet:
1.Slide trivet into freezer.
2.Lower trivet into place.
Removing freezer basket (bin)
(Models RS22AR and RS25AW) To remove:
1.Slide forward to the guide stops.
2.Lift front until it clears stops.
3.Slide out the rest of the way.
To replace:
1.Place on the slides.
2.Lift slightly until the stops clear the front of guides.
3.Slide in the rest of the way.
Removing and adjusting freezer shelves
To remove shelf:
1.Remove food from shelf.
2.Lift right side of shelf off wa.ll supports.
3.Slide left side of shelf out of supports.
4.Replace in reverse order.
To adjust:
1.Remove shelf as above.
2.Slide supports upward and remove.
3.Slide supports downward into new position.
4.Replace shelf.
NOTE: The
Changing the light bulbs
Electrical Shock Hazard
Unplug the refrigerator or discon- nect the main electric power supply to the refrigerator. Failure to do so can result in electrical shock or injury.
To change refrigerator light:
1.Disconnect refrigerator from power supply.
2.Remove the bulb from the socket located behind the Control Console and throw the
3.Replace with a
4.Reconnect power supply.
To change freezer or crisper light (on some models):
1.Disconnect refrigerator from power supply.
2.Grasp front of light shield.
3.Pull bottom of shield forward until it snaps free.
4.Remove bulb.
5.Replace with a
6.Press light shield straight on until it snaps into place.
7.Reconnect power supply.
To change upper freezer light (RS25AW):
1.Disconnect refrigerator from power supply.
2.Lift top of light shield up and pull shield out.
3.Remove bulb from socket.
4.Replace with a
5.Place shield over bulb and snap into place.
6.Reconnect power supply.
To change dispenser light (RS25AW):
1.Disconnect refrigerator from power supply.
2.Remove bulb from the socket inside the dispenser area.
3.Replace with a
4.Reconnect power supply.
NOTE: Not all commercial appliance bulbs will fit your refrigerator. Be sure to replace a bulb with one of the same size and shape.
Removing the base grille
Metal clips
Defrost pan
To remove:
1, Open the refrigerator and freezer doors.
2.Pull grille outward.
3.Do Not remove Tech Sheet fastened behind grille.
To replace:
1.Line up grille support tabs with metal clips.
2.Push firmly to snap into position.
3.Close the refrigerator door.
See cleaning instructions for defrost pan and condenser coils on page 9.
Page 6