Using your refrigerator
Setting the control .. .
The control for the refrigerator temperature IS in the refrigerator When the refrigerator IS plugged in and the run switch is moved to RUN
Give the refrigerator time to cool down com- pletely before adding food. (This may take sev- eral hours )
This setting should be about right for normal
household refrigerator usage.
The control will be set about right when milk or juice is as cold as you like. In hot weather or if the door is opened often, turn the control to a higher number to keep the temperature you like If the milk or juice is too cold or refrigerator items start to freeze, turn the con- trol to a lower number or adjust the freezer tray damper. Wait 24 hours after an adjustment is made before further chanae is made to the controls
l Set the THERMOSTAT CONTROL to 3
The freezer tray..
The freezer tray is located under the freezer com- partment.
The damper at the rear of the freezer tray helps control the refrigerator temperature for warm weather operation. The damper can be adjusted for proper cooling and defrosting of the refrigerator:
To adjust the damper:
I. Pull out the freezer tray.
2.Lift out the damper from the rear of the tray.
3Slide damper into the desired position.
NOTE: “B, C, D” positions provide fine cooling adjustments to best meet your cooling needs in warm weather.
Damper | \ |
| ||
Positions | \ |
| ||
A | - | [Closed] |
| |
B | ~ |
| - +sition | for normal |
C- | - |
| cooling and | defrosting |
u |
|
|
| |
E | - | [FULL Open) |
| |
weather setting.
Changing the light bulb...
WARNING: Before removing the light bulb, either unplug the refrigemtor or disconnect
the electricity leading to the re- frigemtor at the main power supply. Shock and injury can occur if elec- tricity remains connected.
I, Reach behind control console to find bulb.
2 Remove bulb.
3.Replace with a 40.watt (maximum) appliance bulb