![](/images/new-backgrounds/1084099/8409911x1.webp)
7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.
8.Place the free end of the tubing into a container or sink, and turn ON main water supply and flush out tubing until water is clear. Turn OFF
Connecting to refrigerator:
1.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help prevent damage to the tubing when the refrigerator is pushed back against the wall. Move to step 2.
2.Turn
Base Grille
To remove the base grille:
1.Open the refrigerator door.
2.Grasp the grille with both hands.
3.Lift up and tilt the bottom of the grille toward you.
NOTE: Do not remove the Tech Sheet that is fastened behind the grille.
To replace the base grille:
1.Open the refrigerator door.
2.Place upper clips in openings in the metal panel.
3.Roll the grille down toward the refrigerator until it snaps into place.
1.Tube Clamp
2.Copper Tubing
3.Compression Nut
4.Valve Inlet
3.The ice maker is equipped with a
4.Plug in refrigerator or reconnect power.
6