Stanton C.504 manual Sampling, To Play the sample, To Stop the sample, Sampler Loop

NOTE:

More than 3 seconds after pausing, reverse play cannot be performed.

In the reverse play mode, flash start, creating the looping, loop play, and auto cue functions do not work.

However you can create a sample in reverse mode.

3-6. Sampler

The C.504 includes eight seconds sampler on each player (CD1=8sec./CD2=8sec.). NOTE: the sample is played simultaneous to any other audio being played.

By default the sample is played back as a single sample, one time per activation.

Sampling

NOTE:

The three buttons (1/IN, 2/OUT, and 3/RELOOP) are shared for MEMORY/CUE, SAMPLER, and LOOP functions. Therefore, only one of these three functions (MEMORY/CUE, SAMPLER, or LOOP function) can be used at a time.

1.Press the SAMPLE button to enter the unit into SAMPLER mode. “SAMPLE” indicator in the LCD will light.

2.Press the IN button when playing or pausing. IN Button will light and OUT button will start flash- ing.

3.Press the OUT button when playing or pausing. Both IN and OUT buttons will light.

NOTE:

If less than eight seconds elapse, or if the end of the track is reached without pressing the OUT but- ton, the end point of the sample will automatically be set to the end of track.

To Play the sample

When IN and OUT buttons are light, press the RELOOP button; this starts the sample from the beginning.

To Stop the sample

When sample is playing, press the SAMPLE button or any other Bank Mode button (MEMORY/CUE or LOOP) to stop the sampler.

Erasing the recorded sample and re-sampling

Recorded sample data cannot be erased but, it can be over written.

Follow the directions under “Sampling” to overwrite and re-sample.

Sampler Loop

Pressing and holding the SHIFT button then pressing the SAMPLE button turns the sampler loop play on and off. When sampler loop play is activated, LOOP indicator will display in the LCD. O— is a single sample played when RELOOP is pressed. O—Ois a looped sample played when RELOOP is pressed.