Whirlpool W10529641A manual Dryer Care, Cleaning the Dryer Location, Cleaning the Dryer Interior

Page 13

DRYER CARE

CLEANING THE DRYER LOCATION

Keep dryer area clear and free from items that would block the airflow for proper dryer operation. This includes clearing piles of laundry in front of the dryer.

CLEANING THE DRYER INTERIOR

To clean dryer drum

1.Use a mild hand dish detergent mixed at a low concentration with very warm water, and rub with a soft cloth.

2.Rinse well with a wet sponge or towel.

3.Tumble a load of clean clothes or towels to dry drum

OR

Use a microfiber cloth and hot water in a spray bottle to clean the drum and a second microfiber towel to dry.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the rear of the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

REMOVING ACCUMULATED LINT

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified appliance servicer or ventilation system cleaner.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

CLEANING THE LINT SCREEN

Every load cleaning

The lint screen is located in the door opening of the dryer. The control panel has an indicator light to remind you to clean the lint screen after each load. A screen blocked by lint can increase drying time.

To clean:

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

nDo not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

nIf lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements” in the Installation Instructions.

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash:

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Reinstall screen in dryer.

13

Image 13
Contents W10529641A W10529643A SP Use & Care Guide Guide d’utilisation et d’entretienDryer Safety Table DE Matières Table of ContentsPage Pedestal AccessoriesStack Kit WorksurfaceMaintain good airflow by Check Your Vent System for Good AirflowTips for getting the best performance from your steam dryer Cycle Models Control Panel and FeaturesCycle Signal on some models Damp Dry Signal on some modelsCycle Status Lights TempCycle Guide Automatic Cycles Temperature Level TimeOptions Load Size RecommendationsItems to Cycle Drying Default Available Refresh Cycle Drying Default Available Items to dryTemperature Time Cycle Guide Manual CyclesClean the lint screen Using Your DryerTouch Power Load the dryerTo change the drying settings Adjust cycle settings, if desiredSelect Wrinkle Shield, if desired Touch and hold START/PAUSE to begin cycleAdditional Features Cycle Status IndicatorsUsing the Drying Rack To use the drying rackCleaning the Dryer Interior Cleaning the Dryer LocationCleaning the Lint Screen Dryer CareSpecial Instructions For Steam Models NON-USE, STORAGE, and Moving CareIf you experience Possible Causes Solution TroubleshootingDryer Operation Unusual NoiseOn some models For steam On some models Clothes areDryer Displaying Code Message or Indicator Is Lit This limited warranty does not cover Whirlpool Corporation Laundry WarrantySécurité DE LA Sécheuse Page Piédestal de AccessoiresEnsemble de superposition Surface de travailCirculation d’air adéquate Tableau DE Commande ET Caractéristiques Bouton START/PAUSE mise en marche/pause Bouton Power mise sous tensionGuide DE Programmes Programmes Automatiques Articles Temperature DuréePar Options Détails du programme Sécher De sechage Séchage Défaut DisponiblesGuide DE Programmes Programmes Manuels TemperatureDisponibles Utilisation DE LA Sécheuse Appuyer sur mise sous tension PowerNettoyer le filtre à charpie Charger la sécheuseSélectionner Wrinkle Shield, si désiré Sélectionner les réglages de programme, si désiréProgrammes automatiques Programmes manuelsPour changer les réglages de séchage Témoins Lumineux DE ProgrammeUtilisation DE LA Grille DE Séchage Caractéristiques SupplémentairesUtilisation de la grille de séchage Entretien DE LA Sécheuse Nettoyer L’EMPLACEMENT DE LA SécheuseNettoyage DE L’INTÉRIEUR DE LA Sécheuse Retirer LA Charpie AccumuléeInstructions Spécifiques Pour LES Modèles Vapeur Fonctionnement de la sécheuse DépannageSons inhabituels Sur certains modèles Les Résultats de la sécheuseSur certains modèles Pour les Résultats de la sécheuse suiteSi les phénomènes Suivants se Causes possibles ProduisentMessage codé ou un témoin lumineux s’allume Page Page Garantie DES Appareils DE Buanderie DE Whirlpool Corporation Our consultants provide assistance with If you need replacement parts or to order accessoriesNos consultants fournissent ’assistance pour Pour plus d’assistance