Solid State Logic 82S6XL090A owner manual Mounting, Connection

Page 11

Installation and Operation

3.2Mounting

This unit is designed to be rack-mounted. It is 1 RU (44.5mm/1.75 inch) high, its depth is:

325 mm/12.8 inches not including heatsink.

365 mm/14.3 inches including heatsink

400 mm/15.75 inches including connectors

The XLogic E Signature Channel units incorporate reinforcement brackets into the chassis and so are suitable for direct rack-mounting. A 1RU space should be left above each unit to ensure adequate ventilation.

3.3Connection

There are five connectors on the rear panel:

• OUTPUT

(male XLR)

• KEY IN

(female XLR)

• LINE IN

(TRS jack socket)

• LINK

(TRS jack socket)

• INPUT

(female XLR)

OUTPUT

KEY IN

LINE INPUT

 

 

IN

LINK

The XLR labelled ‘INPUT’ is for microphone signals; the ‘LINE IN’ jack socket is for line level signals such as a synthesiser or DAW output. Neither input is suitable for use with guitar pickups, piezo electric bugs etc.

If you have more than one unit, the dynamics side-chain of multiple units may be linked together by connecting the ‘LINK’ jacks together using a mono or stereo jack-to-jack cable(s).

The ‘KEY IN’ XLR provides line level access to the dynamics side-chain to enable the dynamics to be keyed from external sources.

The XLR labelled ‘OUTPUT’ is a line level output; connect this to your recorder, workstation or mixing desk.

Page 7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Signature Channel Page XLogic Solid State Logic Contents XLogic E Signature Channel rear XLogic E Signature Channel frontIntroduction WarrantyWarranty Repairs Out of Warranty RepairsDefinitions Safety considerationsElectrical Safety Warning InstallationCE Certification Graphical SymbolsMains Supply and Phases Mains Isolation and Over-Current ProtectionVoltage Selection InstallationConnection MountingSignature Channel Block DiagramListen Mic Compressor OperationInput Section Compressor/Limiter Dynamics SectionFilters Section Expander/GateOutput Section Equaliser SectionSide Chain Processing Order Signal RoutingChannel Processing Order Stop looking we left this page blank… Appendix a Internal Links and Fuses Link Appendix B Connector DetailsInput Output Line KeyMicrophone Input 1 Transformer Coupled Appendix C Performance SpecificationMeasurement Conditions Measurement ReferencesChannel Output Microphone Input 2 Electronically BalancedLine Input Equaliser Expander/Gate Controls DynamicsCompressor/Limiter Controls Output Stage Appendix D Calibration InformationLMF EQ Maximum Gain Meter CalibrationEQ Alignments LF EQ Maximum GainDynamics Adjustments Appendix F Environmental Specification Appendix E Physical specificationAppendix
Top Page Image Contents