Whirlpool 2180913 manual Changing The Bin Door And Lower Panels, Thermostat calibrations

Changing The Bin Door And Lower Panels

The storage bin door is designed to accept an optional decorative wood panel of your choice. The wood panel should be no more than

l/4 inch (6 mm) thick. Cut it to the same size as the production metal panel.

To change the bin door panel:

I. Open the bin door.

2.Remove the two screws on top of the door which hold the handle.

3.Remove the handle and handle insert.

4.Slide the metal panel out.

5.Break off all door insulation ribs to allow room for the wood panel’s thickness.

6.Slide the wood panel into the door frame.

7.Replace the handle and screws.

To change the lower panel:

1.Remove the three screws that hold the lower panel assembly to the ice maker.

2.Remove the two screws on the top of the panel assembly.

3.Slide the metal panels and spacers out.

4.Slide the wood panel into the door frame.

5.Replace the top of the panel assembly.

NOTE: Make sure the galvanized panel is replaced in back of the panel assembly.

Bin door	,
11‘AI”
I(266 mm)	II
	DIMENSIONS
Lower
panel
11’%6”
(303 mm)

Break off all door insulation ribs to accept 1/4”(6mm) thick wood panels

Thermostat calibrations

If ice maker is installed above 2000 feet (600 m) above sea level, the Bin and Ice Thickness Thermostats must be adjusted to a warmer setting. Disconnect electricity, remove

thermostat, and follow the directions for turning the altitude adjustment screw as shown in the label on each thermostat.

Shipboard operation

When this ice maker is installed aboard a ship, it may be necessary to purchase and install a water deflector. The deflector hangs between the lower edge of the evaporator and the cutter

grid. It keeps the water flowing over the evaporator from spilling into the storage bin area. Order the necessary parts from your local ice maker dealer.