Whirlpool 2180913 manual Check Operation, Replace grille

Page 9

Check Operation

	Start the unit by turning the service	d
	switch to “ON”and opening the line	d
	switch to “ON”and opening the line
	water valve.
	NOTE: Left is “OFF”- Middle is “ON”-
	Right is “CLEAN.” In “CLEAN”position,
	only the pump operates.
	Check condenser fan to make sure it is
	revolving. Check for airflow. Do not	d
	insert hand into fan area.	d
	insert hand into fan area.
	Water will not enter pump pan until
	freezing plate gets cold and machine
	goes into a harvest cycle.

Check for even water flow over freezing plate. Unit must be level for proper operation.

Check for desired cube thickness and after 24 hours adjust if necessary. Max- imum ice yield will be obtained with ice thickness at %” (13 mm) to %” (16 mm).

Replace grille.

Image 9

Contents Installation Changing The Bin Door And Lower Panels Thermostat calibrationsShipboard operation Unpack General InformationUtilities Locate UnitLevel unit ForWater observe Local codes Use VI 6 mm OD soft copper tubing forConnect drain pump Connect to drain observe local codesUnit is provided with a gravity drain For The Electrician Electrical1 requirementsGrounding method How The Ice Maker Works Things To RememberInstructions are located on the inner door panel Operating Instructions Unit Wiring DiagramsReplace grille Check OperationNe pas oublier Schema de cdblageUtilisation de la machine 6 glaqons sur un bateau Italonnage des thermostatsRenseianements Choix de l’emplacementCwh6raux DbballageLes Mise d’aplombRaccordement B I’hgout Raccordement a la pompe d’bacuationObserver les dispositions des codes loeaux Instructions & I’intention de Wlectricien Spkifications de I’alimentation klectriqueM6thode de liaison ZJla terre Ne pas oublier Mode de fonctionnementInstructions d’utilisation Sch6ma de cgblageRisque de choc electrique Contr6le du fonctionnement