Whirlpool MH7lOOXY manual Audible Signals, Setting the Clock, Number Pads, Fan and light Pads

Page 6

Number Pads

Once you’ve touched Command Pad to tell the oven what you want it to do, you’ll touch Number Pads to tell it...

-a time.

-a Cook Power.

-a food temperature.

-a food setting.

Fan and light Pads

The six pads at the bottom of the control panel control the 2-Speed Exhaust Fan and the Cooktop Light.

Touch Fan Pad for the desired fan speed.

(NOTE: If the temperature gets too hot around the microwave oven, the exhaust fan in the

vent hood will automatically turn on the LOW setttng to protect the oven. It may stay on up to an hour to cool the oven. When this occurs, the Pan Pad will not turn the fan oft.)

Touch Light Pad for the desired cooktop or countertop lighting.

Audible Signals

Audible signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Four beeps signal the end of a Cook or Defrost cycle. Two beeps will sound between cycles. A reminder tone will sound every 60 seconds after cooking is done to remind you that something has been left in the oven. A 3 second tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.

To remove the programming tone and reminder tone (the Minute Timer signal will not be removed):

l Open the door.

l Touch CANCEL twice, then touch START.

l Programming and reminder tones will be cancelled.

To replace the tones:

l Repeat the steps above.

NOTE: If your electricity goes off, the tones will be replaced when the electricity comes back on.

Setting the Clock

When the oven is first plugged in, a tone sounds and the Display shows “88:88:’ If the electric power ever goes off, the Display will again show all 8’s when the power comes back on.

You can cook or use the Minute Timer without setting the Clock, but the Display will be blank after cooking.

DO THIS...

THIS HAPPENS...

 

 

The Display will show a “0”and the

 

colon will start to flash. The first

 

Number Pad must be touched within

1. Tout :h CLOCK SET.

5 seconds

or the Display will go

blank. If this happens, touch CLOCK

 

 

SETagain

and continue.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Model MH7lOOXY Contents Before you install your microwave oven Important Safety Instructions Display/Clock Indicator Lights Command PadsMicrowave oven controls Number Pads Audible SignalsSetting the Clock Fan and light PadsMinute Timer This This HappensCooking at High Cook Power Changing the Minute Timer Cancelling the Minute TimerCooking in Your Microwave Oven Cooking at Lower Cook Powers COUd dQWflChanging the Cooking Time Nnn EW-lk Dawl-lUsing Auto SET Changing the Cook PowerAuto Set Time Page Changing the Pre-programmed Setting Auto Set TempTor Lights Defrosting Additional InformationStanding Time and Cooking Automatically After Defrosting About the Quick Defrost CycleChanging or Adding Defrost Time Cooking with More Than One Cycle at One or More Cook Powers DClWll DOwnCooking with the Temperature Probe This Happens Removing and cleaning the Temperature Probe Changing TemperatureHints for Using the Temperafure Probe DO...DON’T Probe Cooking TipsUsing Pause Using Pause with Quick DefrostUsing Keep Warm Adding Pause Between CyclesTo Automatically Follow Another Cycle Using Auto Start Page Smoke Deflector Accessory Kit Other Operating HintsBi-Level Cooking Rack Cleaning the Microwave OvenCleaning the Rack Inserting the RackCaring for the Filters Cook-top light Oven LightOperating safety precautions Mode Mixercover General information Before calling for assistanceIf you need service Page Page Warranty
Top Page Image Contents