Audible signals
Audible signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 60 seconds after cooking is done to remind you that something has been left in the oven. A 3 second tone signals the end of the Minute Timer function.] If you don’t hear a tone, it is because
of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone and reminder tone:
l Open the door.
l Touch CANCEL twice, then touch START.
l Programming and reminder tones will be cancelled.
To replace the tones:
l Repeat the steps above.
To remove all tones, except the Minute Timer signal:
l Open the door.
l Touch CANCEL twice, touch 0, then touch START.
l All audible tones (except Minute Timersignal) will be cancelled.
To replace the tones:
l Repeat the steps above.
Setting the clock
You can cook or use the Minute Timer without setting the Clock, but the Display will be blank after cooking.
When the oven is first plugged in, the Clock/Display shows 88:88. If the electric power
ever goes off, the Clock/Display will again show all 8’s when the power comes back on.
DO THIS... | THIS HAPPENS... |
I. Touch CLOCK SET.
3. Touch START.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The colon will stop flashing. The Clock is set.
If you have touched in an incorrect time, such asl2:65, “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To ethe Clock, touch CLOCK SET.The current time will show on the Display and the colon will flash. Continue to set the Clock as shown above.
6