Programming tone
Each time you touch a pad you will hear a tone. If you don’t hear a tone, it is because the instruction is not correct, or because the tones have been removed.
EXAMPLE: If you touch a Number Pad before you touch a Command Pad, you will not hear a tone. The instruction is not correct.
If you | want | to | remove | the | If you want | to replace | the | If you | want | to | remove | all | |||||||
progmmmlng |
| tone: |
| programming | tone: |
| tones, |
| except | the | minute | ||||||||
l | Open | the | door. |
|
| l | Open | the | door. |
| timer | signal: |
|
|
|
| |||
l | Touch CANCEL | twice, | then | l | Touch | CANCEL twice, | then | l | Open | the | door. |
|
| ||||||
| touch | START. |
|
|
|
| touch | START |
| l | Touch | CANCEL twice, | touch | ||||||
l | The tone | will | not | sound for | l | The tone | will sound for any |
| 0, then touch | START. |
| ||||||||
| any | touch. |
|
|
|
| correct | touch. |
| l | All audible | tones | will | be | |||||
|
|
|
|
|
|
|
|
|
|
|
|
| cancelled. |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
| l | To replace |
| the tones, |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
| repeat | the | above | steps. | |||
Setting the clock
When the oven is first plugged in, a tone sounds and the display shows 88:88. If the electric power ever goes off, the display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking.
DO THIS... | THIS HAPPENS... |
1. Touch CLOCK SET.
2.Touch Number Pads for the correct time of day.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
3.Touch START.
If you have touched in an incorrect time, such as12:65, “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To Etfhe | clock, | touch CLOCK | SET.The current | time | will show on the Display |
and the colon | will flash. | Continue to set | the clock as | shown | above. |