Unitech PA966, PA967 user manual Backlight Setting, Warm Boot / Cold Boot

Page 31

PA966/967 User's Manual

Backlight Setting

Because the power consumption of the LCD backlight is high, turn off the backlight function if it is not necessary. If a backlight is required, select the “automatically turn off the back-light” function.

To change backlight settings, select Settings / Control Panel from the Start menu, and then double tap the Display icon.

Tap the “Backlight” menu item to display the following three selections:

Automatically turn off the backlight when using battery power:

Tap the check box to toggle this function. Available idle times are: 15 and 30 seconds; and 1, 2, and 5 minutes.

Automatically turn off the backlight when using external power:

Tap the check box to toggle this function. Available idle times are: 15 and 30 seconds, and 1, 2, 5, 10, 15, and 30 minutes.

Automatically turn on the backlight when any key is pressed:

This function is activated by the PA966’s keypad rather than the Windows

CE keyboard.

Warm Boot / Cold Boot

Warm Boot

•Via Hardware: To perform a warm boot while the PA966 is operating, insert the end of an unfolded paperclip into the reset hole on the back of the terminal, right below the SD Card compartment cover.

•Via Software: Under the Windows folder of your terminal, locate the file BootMode.exe, execute the program, and confirm the warning message.

WARNING: Warm Boot will cause unsaved data to be lost.

27

Image 31

Contents PA966 / PA967 Portable Terminal Page Page Page Introduction Unitech PA966 & Accessories Tour of the Unitech PA966 First Steps with the Unitech PA966 Installing the Battery PackCharging the Main and Backup Batteries for the First Time Supplying Power to the PA966Protective Screen Film Using the StylusFirst Operation of the Unitech PA966 Exiting Date/Time Properties Settings Setting Time Zone, Date, and TimeSetting the Time Zone first Setting the Year and MonthFlash Memory Alpha KeypadKeypad Layout Software Keyboard Windows CE Keyboard Useful HotkeysModifying the Scanner Settings Using the Built-in ScannerScan2Key Bar Code Symbologies Suffix 2D SymbologiesData Options PrefixTransmit Function Code Proximity Reading OptionsScanning Options Replace Suffix with Carriage ReturnImaging Options Power Management OptionsTimeout To Sleep Imager Idle TimeoutMiscellaneous Options Power On DelayRe-Open Scanner Port After Resume Power Enable Log scanner.txtShow Data Only 1D ScanningAuto-Scan Show Sequence Number Reset Sequence NumberClear Window Save To File2D Scanning Enable ScanSave Image Image ScanningScan2Key Version Charging the Main and Backup Battery for the First Time Charging the Lithium-Ion Battery PackPower Status Indication Check Battery Status Checking Main and Backup Battery StatusHow to Save Battery Power Enter Power PropertiesWarm Boot Backlight SettingWarm Boot / Cold Boot Automatically turn on the backlight when any key is pressedCold Boot Storage and Safety PrecautionsCharging Considerations Docking Station ConnectingIntroduction Serial or USB CableActiveSync InstallationPage Page Mobile Devices Features Using the Mobile Devices WindowChanging Communications Settings To turn on IrDA SynchronizationFiles What Gets SynchronizedChanging Synchronization Options InBox Installing and Removing SoftwareSending and Receiving E-Mail with InBox Sending Mail Remotely Setting Up Remote MailWork Remotely Sending Messages Receiving MessagesBluetooth Setup Wireless CommunicationBluetooth ActiveSync Page OS and Software Programming Tools CPU / MemoryMechanical / Environmental Interface Port PowerInput / Output 1D Scan Engine 2D Scanner Symbologies 1D Scanner Symbologies2D Scan Engine Docking Station Pin Assignment for Charge / Communication PortFactory default settings and data will be lost Perform a cold boot Warning Terminal will be reset toCanadian Compliance Statement FCC StatementEuropean Conformity Statement Unitech America