Broan RM503004, RM503604 manual Install the Hood, NON Ducted CONFIGURATION, cont’d

PREPARE THE HOOD

NON - DUCTED CONFIGURATION, cont’d.

8.Carefully place the lower decorative flue into the recessed area of the range hood top. Fig.7

9.Carefully slide the upper decorative flue down inside the lower flue.

Note: air vents must be up. Fig.7

10.Secure the recirculation plenum to the upper flue with (4) flat head screws. Fig.9

INSTALL THE HOOD

Note: at least two people will be required to mount the hood.

PLENUM

4 FLAT HEAD SCREWS

(3.4x15 mm)

UPPER

FLUE

fig.9

1.	Raise the hood into its		HEIGHT	WALL FRAMING
	mounting position.		ADJUSTMENT
			SCREWS
2. Plug the power cord into			(3.9x9.5mm)
	the electric wall recep-		MOUNTING
	tacle. Tuck excess cord		SCREWS
	behind the flue.		(4.8x38mm)	MOUNTING
3.	Align the rectangular			BRACKET
	opening on the back of			MOUNTING
	the hood with the wall-
				SCREWS
	mounting bracket. Gently
				(4.8x38mm)
	lower the hood until it
	securely	engages the
	bracket.	Fig.10		RECTANGULAR
4.	Level the hood.			CUTOUT fig.10
	Height adjustment screws provide
	vertical adjustment.			FASTEN FLUE TO
	Secure the hood with mounting screws			UPPER BRACKET
	(4.8x38mm). Use drywall anchors,			WITH SCREWS (3.9x9.5mm)
	provided, if wall studs or framing are not
	available.
	Secure with (2) mounting screws
	(4.8x38mm). Use drywall anchors provided
	if wall studs or framing are not available.
	Fig.10
5. Raise the upper flue until its holes align
	with holes in the flue mounting bracket
	(located on ceiling). Fig.11
6. Secure the flue with (2) mounting screws				fig.11
	(3.9x9.5mm). Fig.11

8