Broan RM503004, RM503604 manual Operation, Light Bulbs, Controls, Heat Sentry

OPERATION

Controls

The hood is operated using the slide controls under the bottom of the hood.

The light switch turns the lamps on and off. The blower switch: makes it possible to select the motor operating speed.

Position 0: motor off.

The pilot lamp lights up whenever the blower is on.

HEAT SENTRY™

Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above

the cooking surface.

1)If blower is OFF - it turns blower ON to HIGH speed.

2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed.

When the temperature level drops to normal, the blower will return to its original setting.

WARNING

The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.

LIGHT			BLOWER
			SWITCH
SWITCH		PILOT
		LAMP
0	1		0	1	2	3	4
							fig.14

LIGHT BULBS

This range hood requires two light bulbs (included); max 40W, 120V, E12, Type B or Type T8 bulb.

ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.

To change bulbs:

1.Remove the screw securing the light fitting.

2.Pull down lens to remove.

3.Replace with light bulbs of the same type.

CAUTION: BULB MAY BE HOT!

fig.15

fig.16

10