Capresso Impressa J5 warranty Error 6, Error, Reasons, Supplies

Your machine is too cold. The heating sensor does not react. Turn the machine off. Keep the machine at normal room temperature (65º F or higher) for 2 hours. Then turn it on again. If the display still shows ERROR 2 or ERROR 4 call customer service.

ERROR 6, ERROR 7

Turn machine off, turn the main power switch off and unplug machine for a minute. Turn machine on again. If the error message comes up again, try one more time. If the message persists, call customer service.

ERROR 8

Reasons:

1.The used coffee release mechanism got stuck.

2.Drawer was pulled out of the machine during operation.

3.The inner screen of the brew-unit needs to be wiped off. Solution 1: Turn machine off (Fig. 2). Remove the complete drawer. Wait for five minutes. Turn the machine on and wait until a message appears. Insert the complete drawer.

Solution 2:

• Turn machine off (Fig. 2).

• Remove the complete drawer and wait 10 minutes for the machine to cool down.

• Reach inside the opening. Reach up, behind the movable flap. Your fingers will touch a round metal surface. You can feel that there is a screw in the middle of this surface. This is the inner screen.

• Take a paper towel and wipe this screen. Replace the complete drawer.

•Turn the machine on. First use the hot water cycle, then try to make a cup of coffee. If the message ERROR 8 still persists call customer service.

24.REMOVING STONES FROM THE BURR GRINDER Occasionally small stones can be found in between coffee beans. They can block the burr grinder. The grinding noise will become loud and no coffee will be ground.

• Turn off the machine by pushing the ON/OFF button (Fig. 2).

• Wait until the machine has shut down completely.

• Turn the main power switch off (Fig 1a).

• Open the bean container lid and remove the bean aroma lid.

• Loosen the screw in the bean container (Fig. 28) and lift the finger protection.

• Remove the beans.

• Attach the burr grinder release tool (this tool is located in the Welcome Box) to the upper burr (Fig. 30). If you cannot find this tool call 1-800-220-5701 and we will send the tool to you free of charge.

• Turn the tool slowly counter-clockwise until the stone becomes loose and remove the stone.

Attention: Do not try to turn the tool clockwise. Close the finger protection and tighten the screw.

Turn machine on and test the grinder without beans to see if the blockage has disappeared.

25.SUPPLIES

The following supplies are necessary to keep your machine in good working order. You can purchase these supplies:

• from your local Jura-Capresso retailer,

34.