CHAPTER 1
Front Panel Features
1 | 2 | 3 | 4 |
5 | 6 | 7 | 8 | 9 | 10 | 11 |
12 | 13 | 14 | 15 | 16 | 17 | 18 |
1. Power
This button turns the
The blue LED above the power switch is on when the
To fully turn off power to the TGR- 401, for example if you are going on vacation for a week or two, then use the rear panel power switch.
Press Zone 2 select (14) followed by this power button to turn on Zone 2.
2. Main LED
This blue LED is on when the Main zone is on. It flashes red when the remote control is used.
3. Zone 2 LED
This green LED is on when Zone 2 is on.
10
4. Display
This display shows which input is selected, the volume level, sur- round mode, and other features such as the setup menus.
5. Input
Press this button, then cycle through the inputs with the manu- al selector (9). The LED will light.
6. Mode
Press this, then cycle through the various modes with the manual selector (9). The LED will light.
7. Setup
Press this, then cycle through the available setup items with the manual selector (9). Press enter
(8) to select the required setup item. Press Input (5) or Mode (6) to exit the setup menus. The LED will light when in setup mode.
8.Enter
Use this and the manual selector knob (9) during setup (7). When a desired menu item is found, press enter to select that item.
Note: Setup (7) and Enter (8) can be used to increase or decrease dB values within the menus.
9. Manual Selector
Use this to cycle through the various menu items such as the inputs (when input (5) is pressed), the modes (when mode (6) is pressed), and setup (when setup
(7)is pressed).
10.Mute
This turns off the sound. Press it again, or adjust the volume control to return to the previous volume level.
11. Volume
Rotate this manual control clock- wise to increase the volume. The level will appear in the front panel display. Note that the control knob does not rotate when the remote is used. When turning on a new source, make sure the level is low, such as 20, and increase it slowly.
Note: When the
User's Manual